Windows 10: My pc won’t connect to my monitor after a windows 10 factory reset

My pc started acting buggy and lagging recently so I decided to do a factory reset in the middle of the rest my monitor turned off and my pc was still on and running for about five minutes and I didn’t do anything after that five minutes I turned off my pc and turned it on again but my monitor still showed a black screen, I waited a while but still nothing I change out the cable and it still didn’t work, I made sure my monitor worked properly and it did but it just doesn’t work with my pc. And every thing looks fine in my pc so I’m not sure what is wrong.

:)

 

iPhone won,t connect win 10 Pro

 

iPhone won,t connect win 10 Pro

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".