Windows 10: My pc wont reset

So my computer has been crashing and freezing a lot about every 20 minutes it crashes and i have no choice but to reset it but it will not reset it says “there was a problem resetting your pc no changes were made.”

:)

 

PC shut down, wont turn back on

The fan twitch is it powering up and then the psu is noteing a short and cutting out hence why it wont do it again straight after until it's reset, something is blown or shorted out so you need to do as someone suggested and split the pc out then, on a table build the minimum up as he said and step by step see what's happening.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Settings and store wont open, and pc wont reset

Hi Camisado,

Thank you for posting in Microsoft Community and being a part of Windows 10.

I understand the inconvenience you are facing in accessing the operating system.
Now that you have me with you let me take care of this.

We appreciate your effort and time spent in resolving the issue.

Do let us know the following to assist you better with this issue:

• What is the complete error message/ error code of this issue?
• How exactly are you trying to perform reset on your device?

Try the below troubleshooting steps and check if it helps.

Step 1: I suggest you to try the below if not yet tried:

• Open the Task manager. Here’s a tip: Press
  CTRL+Shift+ESC.
• Click File > Run New Task.
• Make sure you have a check mark beside “Create this task with administrative privileges”.
• Type CMD.
• Type the following commands at the CMD prompt:
  

• 
  powershell
  
• 
  Get-AppXPackage -AllUsers |Where-Object {$_.InstallLocation -like "*SystemApps*"} | Foreach {Add-AppxPackage -DisableDevelopmentMode -Register "$($_.InstallLocation)\AppXManifest.xml"}
  
  

6. Close the CMD window.

Check to see if the issue is resolved.

Step 2: I suggest you to create a test user account on your computer and check if the issue persists on that account.

This will let us know if your current user account is corrupted.

Follow:

• 
  Press Windows + X keys from the keyboard, click on
  Control Panel.
  
• 
  Select User Accounts, click on
  Manage another account.
  
• 
  Select Add a new user in PC settings, click on
  Add someone else to this PC and follow onscreen instructions.
  

Refer to: Create a local user account
in Windows 10

Hope it helps. Get back to us with an updated status of this issue and the required information for further assistance.