Windows 10: My pc won't stop blue screening after ram change

So, I bought two 8gb sticks of corsair vengeance ram off of Amazon for £50 to change my crucial 2x4gb to the new 16gb but when I changed it it started blue screening most times after I logged in or just randomly saying error code memory management and other blue screen codes, so I thought maybe I should turn on the xmp profile and maybe that will fix it, so I did that and then it still blue screened. So then I tried changing the frequency, the ram Freq is 3200 so I looked up the problem and someone said to change it to 3000, so I did that but still no luck, so I've been changing to all differe

:)

 

Volume Mute Light won´t change color

Before I follow your suggestions, a quick update: as the updating didn´t seem to work I stopped trying and just left it alone for awhile. About a half hour later I looked over and saw that the mute light was now blue. I tried the button but it and the volume buttons did not work at all. On the screen I was told that I needed to reboot, which I did and now the system has returned back to the way it was before: everything works except that the mute light does not change to blue as it should when the speakers are not muted. WTF?

 

Stop code blue screen sdbus

Hello,

Stop errors (also sometimes called blue screen or black screen errors) can occur if a serious problem causes your device to shut down or restart unexpectedly. These errors
can be caused by both hardware and software issues.

For us to better assist you, we'd like to know the following:

Confirm which build is currently installed on your device. To check, follow the steps below:

• Press Windows key + R, then type in winver.
• Click OK.

• Were there any recent changes made prior to this issue?
• What actions were you performing when normally encounter the said error?

Meanwhile, we recommend performing the suggested steps in this article to
troubleshoot blue screen error on Windows 10.

We'll be waiting for your response.

 

Blue screen and stop code

Hi
Jeferis,

There are a lot of factors for this matter to occur. To isolate the issue, we have some questions for you:

• 
  What activity have you done to
  trigger the NTFS and FAT FILE SYS loop?
  
• 
  were there any error messages?
  
• 
  What troubleshooting steps have you done so far?
  

It is possible that the
Boot
Sequence were corrupted by the previous activity which
triggered the Blue Screen Error and the loop. We recommend that you perform these
suggested troubleshooting
and see if there are any changes:

Startup Repair.


To access the
Startup Repair Screen, turn off the
PC 3-4 times(force shutdown),
while on the Blue screen Error. This will route you to the
Startup repair screen:

Advanced Boot Options > click Troubleshoot > Advanced options > Command Prompt

and run the following command:

Run SFC Scan:  

SFC
will
scan
and
run
an
automatic repair
to any
corrupted system files
that it will detect. We suggest that you perform it twice. To run an
SFC scan, follow these steps:  

• 
  Run
  Command Prompt as Administrator.  
  
• 
  Type
  sfc /scannow
  and hit
  Enter.   
  

Boot Record:

This will fix the corruptions on
boot records or boot
sequence. To run this command, follow these steps:

• 
  Run
  Command Prompt as Administrator.
  
• 
  Type the following command:  
  
  • 
    Bootrec /fixMBR  
    
  • 
    Bootrec /fixBoot
    
  • 
    Bootrec /rebuildBCD
    

Update us on how it goes.

Regards.