Windows 10: my printmaster 18.1 isn't working

My Print Master 18.1 isn't working right. Something is missing. The page changer is missing.

:)

 

printmaster 17 not working

Neither PrintMaster 17 nor PrintMaster 18 is fully-compatible with Windows 10 Version 1703 or higher - at least according to this fairly recent, archived discussion =>
Windows 10 Compatibility of much older Program

If PrintMaster 17 was working prior to installing the (Fall?) Creators Update, you were just lucky.

Perhaps Broderbund Support might be able to assist you further? =>
http://support.encore.com/technicalsupport/

PS: This page suggests that PrintMaster v8 Platinum is supported in Win10 but I wouldn't put money on it =>

http://www.broderbund.com/c-180-works-with-wind...

 

Printer isn´t working after latest update.

After the latest update from Windows, my Canon Pixma ip6600 printer isnt working. In Device Manager it shows up as working properly but when I go to print it isn´t listed as an option in any programs. Troubleshoot suggests it´s a USB 2 printer on a USB
3 port and that that´s the problem but that cant be since it worked fine before the update. I´ve tried to uninstall and plug it back in but that doesn´t work either.

 

Cortana isn´t working

When I hit enter, it did something, but there´s still no Cortana, even after restart. So I tried it again, but now it says that it failed, because it´s already installed and it´s working in PC. So it should work, but Cortana still isn´t here.