Windows 10: My SSD Files previously used as OS drive keep reappearing after format and clean

Hello experts,I have a twinmos 128 GB ssd previously used as OS in my laptop, switched with new storage, now twinmos unused.Recently I bought an enclosure to use as pendrive but after formatting all the data comes back automatically.I tried via diskpart, followed several ways as below: list disk select disk n attributes disk clear readonlythen list disk select disk n clean create partition primary format fs=ntfs quick assign letter=HAll happened but data comes back again.Also tried so many methods found in several forums, but no help, data comes back.Please Help.Thanks.

:)

 

Format SSD drive or any drive

Hi Thomas

Think of a hard drive or SSD as a book . . .

A Quick Format basically deletes the contents page (File Allocation Table), whereas a Long Format will also delete all the pages (Files)

If a quick format is taking 2 hours on your SSD and you are experiencing problems with Windows, when only performing a Quick Format, then I would suggest the formatting operation is not the problem, most likely that SSD has a problem. A Quick format on that
drive, should take approx. 10 minutes . . .

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!

 

Clean install Windows 10 on new SSD to rplace failing HDD and corrupte

How to do a clean install of Windows 10 on a new SSD that will replace a failing HDD and corrupted data files in a Laptop PC?
There seems to be a lot of old posts that touch on various subjects that I need help with but none that lump them all together. This is a clean install of Windows 10 on a new SSD on a Laptop PC that was previously upgraded to Windows 10 with the free upgrade just prior to the free upgrade becoming unavailable. About 6 months ago intermittent weird problems began to appear and with the help of various support groups and Windows Community we came to the conclusion that the HDD needed to be replaced(failed Seagate's drive test) with an SSD (My Choice) and a clean install of Windows 10(corrupted data files in the OS).
I was given a URL to download and burn to DVD an ISO file of Windows 10 PRO 64bit OS. I purchased a 240GB Sandisk SSD. I don't need to partition this drive as the single C: partition is adequate for size and speed.
Is there a step by step procedure listed somewhere that preps(formats?) the SSD using disk management for Windows 10 and then using the ISO file that I burned to a DVD, installs Windows 10 on to my SSD? I am not familiar with ISO files and am assuming that is something that is sent to you to boot from and install from when you order SW from MS.