Windows 10: my windows reset and stuck on 1%

my windows reset and stuck on 1% and when i turned the pc off, it will windows volume2 and it restart again and again and now i can't do nothing ,please help me

:)

 

Windows 10 stuck at resetting this pc 1%

Hi Emmarienelle,

Resetting Windows 10 is an ideal solution for users to fix system problems or software compatibility issues. However, things might get complicated when your PC gets stuck or freeze while resetting. We recommend following these steps to resolve the issue:

• Fix Windows 10 fail to reset issue by hard booting PC and performing a clean reset:

• Press power key for 8-10 seconds to start a hard boot. Do this for three to four times.
• Enter Windows 10 Automatic repair options.
• Try a clean reset from the Automatic repair options.

• Download Windows 10 ISO file and perform a clean install in your PC.

• Download Windows 10 ISO installation file.
• Perform a clean install of Windows 10.
• Try performing a clean reset again.

Let us know if you need any other help.

Regards.

 

Windows 10 system reset stuck at 1%


Hello everyone. Last night I upgraded my laptop running Windows 8.1 to Windows 10 with the media creation tool. I wanted to have a clean install, so I went into the settings and reset my PC so it would be like a clean install instead of using the ISO and booting from a usb disk drive.








It has been a couple of hours since it started and it has been stuck on "Resetting this PC 1%". What should I do in this scenario to fix it? Thanks.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".