Windows 10: need help after factory reseting my pc their is still a user and it says user could not be...

After I did a reset/remove everything on my pc. There was still a user and when I entered the password it said user could not be loaded and when I tried to go into safe mode or do anything else in the Shift+ restart my monitor would slowly fade into a black screen and my monitor would not put out a output but when I clicked ESC on my keyboard, it would bring back the input from the pc into the monitor and then bring me back into the lock screen and I'm just stuck there. Please help. Thanks

:)

 

Current active users that are friends

The other reason I suggested this is that users can add characters to their username that are not alphanumeric (e.g. user*). This confuses things somewhat when looking at the list.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Other Users-PW Reset

Hello,

I request you to try the steps below:

• Press "Windows" + "R" on the keyboard.
• Type "netplwiz" and press Enter key.
• Select the user account and click on "Reset password"
• Enter the new password.

You may also see the data of all the user accounts by following the steps below:

• Press "Windows" + "R" on the keyboard.
• Type ".." and press Enter key.

I hope this helps you. If you have any further queries, feel free to contact us. We will be happy to help you.



Thank you.