Windows 10: Need to keep reinstalling SSD otherwise I keep getting BSODs

Hello, every couple weeks I keep getting BSODs. A temporary fix I found is that I need to remove and reinstall my m.2 SSD into my motherboard. This only fixes the problem for a couple of weeks until I keep getting BSODs again, so does anybody know what can cause this? Is this a motherboard problem or an SSD problem? I have reinstalled windows multiple times and it does not seem to fix the problem. I have gotten a couple of different BSOD error codes: Kernel_data_inpage_error and critical_proces_died are 2 of them. ThanksI have a 970 evo ssd and a Gigabyte GA-a320m-s2h motherboard

:)

 

Z Book BSOD with Second SSD Drive

Hi all

I have an issue with an HP Z Book. It is a new Generation 6 device and came with a pre-installed second SSD drive.

All worked fine until I tried to put our corporate image onto the primary OS SSD.

Firstly, the new OS installed onto the secondary SSD rather than the primary.

So I disconnected/removed the secondary, recreated the partition on the primary and loaded our stock OS.

The machine now works absolutely fine, as long as I do not try to re-introduce the second SSD drive.

If I reinstall this, the machine boots up OK for a second or two and then BSOD's.

Can anyone suggest the reason for this issue - the BSOD message reported a kernel error.

Any ideas on steps to take to resolve this?

Thanks

Phil

 

Getting BSOD 0x124 error

Ignore what everone said here.

0x124 BSOD is usually related to VCCIO (VTT), run Prime95 version 26.6 with custom sizes of 512K to 640K with 50% of your memory for at least 8 hours.

If you get a 0x124 BSOD, increase VCCIO voltage by small steps, run Prime95 again until your stable.

If you pass Prime95 512K to 640K without a BSOD, then its Vcore too low. I'd suggest running IntelBurnTest with 80% of your memory to verify stability (8 to 12 hours).

Oh, and yeah, if this problem appeared all of the sudden, the reason is CPU degradation, you can prevent it by enabling C-States or adjust your overclock to use lower voltages.

 

AMD FX OC'ers Club

That's what the auto setting will do since you're over the 1333 mark it jumps to the next step which isn't listed or officially supported I assume by that ram.

At this point though I would suggest dropping the multi one step or .5 so that we can get something stable and possibly take the heat issue out of the picture for now.