Windows 10: netsh - system cannot find the file specified

Hi,I am trying to use netsh but is unable to do so, yet I am able to execute netsh when doing show interface. Here is the output of the powershell.PowerShell 7.3.5PS C:\Users\user> netsh interface show interfaceAdmin State State Type Interface Name-------------------------------------------------------------------------Enabled Disconnected Dedicated OpenVPN WintunEnabled Disconnected Dedicated Local Area ConnectionEnabled Disconnected Dedicated Local Area Connection 2Enabled Disconnected Dedicated OpenVP

:)

 

The system cannot find the file specified

In my downloads folder uis a file/folder

I try to delete a file/folder gets message *The system cannot find the file specified.*

files/folder will not delete





Suggestions? Ideas?

 

How to reset whole netsh? (Windows 7)

Was wondering has the commands changed somehow since on Windows XP and on Windows Vista 'NETSH INT RESET ALL' cleaned entire netsh up from top to bottom.

Now on Windows 7 this same command says no go and only way I can see it is by building .cmd/.bat which does something like:

Code: netsh winsock reset all netsh int 6to4 reset all netsh int ipv4 reset all netsh int ipv6 reset all netsh int httpstunnel reset all netsh int isatap reset all netsh int portproxy reset all netsh int tcp reset all netsh int teredo reset all[/quote] now the king of the hill of bugs is this doesn't actually do even it's job even after reboot. values setup to are not reset to defaults. (I know I could add more entire list of entries there is, but looking for clean delete/wipe settings & default everything not to dump entire list of resets.)

So, anyone got a plan B?

 

Bitlocker Error: The system cannot find the file specified

I was encrypting my Drive "D" and system got shutdown due to power loss. After turning on the system I was unable to decrypt the drive. I'm receiving the error "The system cannot find the file specified" while entering the password. I tried below steps but nothing helped.

1. Press Windows key + E, to open File Explorer.
   
2. Navigate to C:\Windows\System32\Recovery.
   
3. Look for REAgent.xml file, right click on it and click on Rename.
   
4. Rename the file to REAgent.old.
   
5. If you receive any prompt click on Yes.
   
6. Start the Bit Locker encryption process.