Windows 10: Netsh

CMDNetshnetshnetsh.exe

:)

 

How to reset whole netsh? (Windows 7)

Was wondering has the commands changed somehow since on Windows XP and on Windows Vista 'NETSH INT RESET ALL' cleaned entire netsh up from top to bottom.

Now on Windows 7 this same command says no go and only way I can see it is by building .cmd/.bat which does something like:

Code: netsh winsock reset all netsh int 6to4 reset all netsh int ipv4 reset all netsh int ipv6 reset all netsh int httpstunnel reset all netsh int isatap reset all netsh int portproxy reset all netsh int tcp reset all netsh int teredo reset all[/quote] now the king of the hill of bugs is this doesn't actually do even it's job even after reboot. values setup to are not reset to defaults. (I know I could add more entire list of entries there is, but looking for clean delete/wipe settings & default everything not to dump entire list of resets.)

So, anyone got a plan B?

 

router logs DoS attack from a local PC....

Well you did not say that you don't really know what you are doing. It's not a problem of course, but it changes things a little.

It's not even clear if the PC or the router is the problem at this time, so I suggested that you disable some unnecessary things which are usually known to cause many problems, sorry if those were too complicated.

• You could reset some network related stuffz on the PC as a next step. Open an elevated command prompt (run as administrator), and enter the followings on the PC:
  netsh int ip reset reset.log
  netsh int ipv6 reset
  netsh winsock reset
  netsh branchcache reset
  netsh advfirewall reset
  (note: You can export your current firewall rules in the "group policy" before the reset if it's needed for some reason)
  
  
• Btw, Would it be a problem to reset the router to the default settings if the things we are trying will not help? There is a menu point for that called "factory settings" (and also a little hole on the back if you prefer that one).. the Administrator username in the router after the reset would be admin and the password is probably on a sticker at the bottom of the router (special settings needed to go online with your ISP might be also necessary)
  This is not needed now (not yet), but perhaps the source of the problem is at the router and not the PC in question, so we may come to that eventually.

ps.: Do you have a second network card you could test in that PC and a different cable to rule out some hardware issues on the PC side?

 

Using netsh wlan commands not working

It comes up in the list of available WiFi networks but it isn't a network that I have ever connected to. I'm connected to my own private WiFi network and have never seen another network show up on the list until now. It has a padlock mark on it which, I think, means I couldn't use it anyway because it's password-protected. I don't want to use it. I just don't want to see it in my Action Center. As I said, I tried a netsh wlan command to block the network, and used another netsh wlan command that was meant to also hide blocked networks from the list, but this rogue network still shows up on the list in my Action Center. It shows up for about 10 seconds, then disappears. Confusing...In fact, it happened again just now...showed up on the list for a few seconds, then disappeared all of a sudden.