Windows 10: Network and Internet Settings Crash - Computer will not reset

I turned on my computer today and found my wifi not connected. After going into setting to try to reconnect, I clicked on the Network and Internet option which then crashed my entire setting page. This has continued to happen even after resetting. I have tried following several threads to fix my computer such as https://answers.microsoft.com/en-us/windows/forum/all/my-windows-10-os-is-completely-broken-and-i-cant/a4fb80ca-f18a-4047-9d34-a51e3fdf742bhttps://softwarekeep.com/help-center/how-to-fix-there-was-a-problem-resetting-your-pc-error-on-windows-10#:~:text=One%20of%20the%20most%20common,at

:)

 

Set Broadband Internet Connection Network Configuration

Hi,

Upon analyzing the details you have provided, kindly run the
Network and Internet Troubleshooter
and check if there's any changes. To run the
troubleshooter,
follow these steps:

• 
  On the search bar, type
  Troubleshooting.
  
• 
  Choose
  Network and Internet.
  
• 
  Run the following
  Troubleshooter:
  
  • 
    Internet Connections.
    
  • 
    Network Adapter.
    
  • 
    Incoming Connections.
    

If the issue persists, we suggest that you try to
renew
your
IP address. To do this, follow these steps:

• 
  Open
  Command Prompt
  as
  Administrator.
  
• 
  Type the following command:
  
  • 
    Ipconfig/release
    and hit
    Enter.
    
  • 
    Ipconfig/renew
    and hit
    Enter.
    
  • 
    Exit.
    

Let us know how it goes.

Regards.

 

W10 Settings crashes when going into Network & Internet

Same issue for me, when entering Network Settings, panel crashes. Device Manager says network devices are working but I have no network. Tried all the steps suggested in prior feed.

 

network settings reset upon boot

the router is set to be a DHCP server - but im trying to run static ip's for the computer. there is a static ip option in the drop down menu, but then i have to manually put in my ecternal ip settings for the internet, which my old router did not ask for...should i set it to static ip and use the settings that the router pulls from the isp via the DHCP setting?

EDIT: i just looked and under "Internet Set-up" its set to DHCP, and under "Network Set-up" i have DHCP disabled.

no, just the firmware that came with it. its a lot more complicated the the router i had been using. i've seen tomato mentioned in the forum quite a few times so that will be my next step