Windows 10: New Build Keeps Hanging Several Event ID's

I recently built my first computer. I've updated all my drivers and the computer runs amazing... expect that it will randomly freeze, and I have to restart. I have several Event ID's and I can't make heads or tails of them. I'm hoping someone can give me some advice. I think that it may have something to do with my processor. I've tried throttling it down but it did not help. I appreciate any and all advice.Event ID'sCritical41Error12201002250560087023Warning13410016 x5I have several other Event ID's that has shown up over the freezes but these are the ones that showed on the last freeze.

:)

 

Kernel-Power event id 41. BugcheckCode 0

Hello,

Thank you for writing to Microsoft Community Forums.

In-order to get more clarity on this issue and to assist you with appropriate troubleshooting steps, reply with answers to the below questions:

1. Are you aware of any changes made on your PC, prior to this issue?
   
2. Is this issue specific while playing a particular game?
   
3. Which edition of Windows are you currently using?
   

A Kernel Power Event 41 can occur in the following scenarios.

Scenario 1: The computer restarts, and there is a Stop error BugcheckCode in the event data.

Scenario 2: The computer is shut down by pressing and holding the power button.

Scenario 3: The system randomly restarts and no Stop error BugcheckCode is listed, or the computer is completely unresponsive (hard hang).

I suggest you refer the article on Kernel
Power Event ID 41 and follow the steps for the scenario that is causing this error on your PC.

Additionally, you can refer the article on Windows
Kernel event ID 41 error "The system has rebooted without cleanly shutting down first" in Windows
and check if that helps.

Regards,

Sandeep Kumar M

Microsoft Community – Moderator

 

Event Viewer problem with latest Windows Build 1607

After installing the new Windows build 1607, the Event Viewer stopped recording events under Diagnostic Performance. (Before 1607 I checked the files located under Windows.old dated 9/23/2016 and located this file which indeed did have a list of events
recorded.)

Since the initial 1607 download there have been two new builds automatically installed on my laptop.



The last step in an automatic download is the RESTART. Prior to my rebooting, I checked the Diagnostic Performance and for sure, these had the list of events.



Rebooting by me, causes the Diagnostic Performance errors to disappear.

As suggested earlier I have run the SFC/DISM commands with no errors reported.

Any Ideas?

Nancy

 

Event ID 10016, CLSID and APPID

Hey, I've been trying to resolve this same dcom issue myself, and I followed the steps you listed @FreeBooter, but when I try to do the last step, I firstly when clicking "edit" get a message saying



And then when I do enter the menu after clicking "ok" on that dialog box, the add button is greyed out.

I'm 100% certain I followed all the steps correctly. I triple-checked it. But no dice...