Windows 10: new laptop cant connect to WIFI

I have this new laptop that cant connect to WIFI. I tried restarting my laptop and the modem and it is still the same. It says no internet connection status.

:)

 

Cannot connect to wifi with laptop

Hi,

We would like to isolate this issue that you're having right now. We suggest that you try the steps below:

• 
  Go to Network and Sharing Center.
  
• 
  At the right pane, click Change adapter settings.
  
• 
  Right click on your connection name (WiFi name) and Properties.
  
• 
  Click the Configure... button.
  
• 
  Go to Power Management tab.
  
• 
  Uncheck/disable the radio button for "Allow this device to turn off this device to save power".
  
• 
  Restart the PC (Important)
  

We will wait for your response.

Regards.

 

Laptop Freezes or wifi gets disconnected and unable to connect to new wifi hotspot when laptop is moved

• #1

I have an Asus X550LD laptop with 8gb ram , graphics card and i 5 processor.

When my laptop is moved, then one of the below mentioned things happen.

1. My laptop freezes totally. It does not respond to any key and then I had to only hard reboot the computer.
2. My laptop gets disconnected to the connected hotspot and then it shows very few hotspot and it is unable to connect to any of them.

It does not happen when the laptop is moved in a certain direction or way. I think it is totally random.

Any help is appreciated.

Thanks in advance.

 

Is it possible to set up a new manual wifi connection from the command line?

I'm trying to work out a solution to set up ad-hock wifi connections in Windows 8.1 based on the suggestions in a post on Micsrosoft's answers site. Is there any way to do the first few steps:

• go to "Network and Sharing Center"
  
• click "Set up a new connection or network"
  
• double click "Manually connect to a wireless network"
  
• enter the SSID of the ad-hoc network (as shown by "netsh wlan show networks") into the "Network name" field
  
• configure security settings accordingly
  
• uncheck "Start this connection automatically" (important)
  

...without using the windows dialogs?