Windows 10: New Simple Volume Wizard does not repond

I've been trying to create a new simple volume on a thumb drive its not working

:)

 

New Simple Volume Wizard does not repond

I recently upgraded to Windows 10 Pro on Dell Latitude E6530 and now when inserting sd card into on-board card reader I get message "directory name is invalid". I've tried the disc management suggestion but when I click on New Simple Volume Wizard, it
does not respond. It is not greyed out so I can click on it but nothing happens

 

New Simple Volume Wizard does not repond

Hi Randy

Make sure that lock is in the unlocked position and see if you can create a new volume on that drive

If not:

Click your Start Button, then just type cmd

From the resulting list, right click Command Prompt and choose 'Run as Administrator'

Run this command and hit Enter:

diskpart

Run this command and hit Enter:

list disk

(Being very careful, make note of the disk number you want to convert and enter it into the next command - replace disknumber)

Run this command and hit Enter:

select disk disknumber

Run this command and hit Enter:

clean

Run this command and hit Enter:

convert mbr

Then close Command Prompt

Open Disk Management again and see if you can now create a new volume on that drive . . .

 

Unable to create simple volume on new 1TB hard drive

Just got a brand new HP computer with windows 10 Pro (64bit) preinstalled on an SSD. I am now adding a 1TB sata hard drive for storing data files. New HDD is installed as Disk 1 and is seen by Windows 10. I initialized it as an MBR basic disc. When I try to go to the next step of creating a volume, I right click on disk 1 and there is no option available to create a new simple volume. There are other volume options (mirror, raid, etc) but they are all greyed out. Simple is not even listed as an option. I went to DISKPART and using clean command, took it back to the start, then initialized it as a GBT. That didn't make a difference. Now I'm back to MBR again. I also did a List Volume command under DISKPART and confirmed there is no volume on this drive. I'm stuck. How can I get this drive to the point where I can format it and use it?
Thanks!