Windows 10: New SSD won't boot

I just cloned my Windows 10 partition to a new SSD, but it won't boot. I had Windows set up to dual boot to Windows XP on another partition on the same HD when I cloned it. I did not move that XP partition to the SSD, is that possibly the reason it won't boot? When I try to boot to the SSD it just gives me a message that there is no bootable drive. This is a bios system.

:)

 

Skype won´t wok in 17063

Skype Won´t work... games won´t work...

Making backup and re-format...

Maybe I Install a Windows 7 again, At least, all of my games run smoothly ...Sadness!!

*Banghead

 

New windows 10 installtion on New SSD - wont boot unless old SSD present

It seems you installed Windows while the both SSDs were connected. This would have caused your current problem. Maybe it is sufficient to do this:

1. Launch the Disk Manager.
2. Right-click drive C:, then mark it as "active".
3. Shut down Windows
4. Open the BIOS and tell it that the new SSD is the primary boot device.
5. Disconnect the old SSD.
6. Boot up normally.

If this does not work then you might have to do this:

1. Disconnect the old SSD.
2. Re-install Windows on the new SSD, using the Media Creation Tool.

 

New SSD wont boot

Hi John

Boot into BIOS, is SATA Mode set to AHCI to enable booting from an SSD drive?

Is the SSD drive set a top of the Boot Priority list?

Did you try connecting that SSD to the SATA Port normally used by your old HDD?