Windows 10: Nightmode multiple Monitors reset after wake up

Hello,I have a problem regarding the nightmode.Problem: second and third monitor ignore night mode after monitors wake up.Steps to reproduce on my setup:1. Have 3 Monitors Main A, B, C plugged in2. Set night mode in settings to 50% All three monitors change accordingly3. Wait until monitors turn off because of power saving option4. Move mouse to wake monitors upState now is:- A has kept night mode, looks like 50% as before- B and C have both night mode completely off bright- Windows settings show that night mode is turned on at 100% slider is at the far right- Changing the setting no

:)

 

Windows move about on multiple monitor wake up

Hi Gareth,

The issue is most likely with the graphics driver. Whenever a single monitor from a multiple display setup in Windows, it will attempt to move everything from that screen onto the remaining screens. Usually, this issue should not occur when suspending, hibernating,
or shutting down. Having said that, we suggest that you update the graphics driver by following the steps on this link:

Update drivers in Windows 10.

In case that the issue persists after following the steps on the link above, we suggest that you update the graphics driver by going to the chipset manufacturer's website.

Let us know how it goes.

 

i have a problem to connect 2 monitors.

Hi Ron,

Thank you for posting your query in Microsoft Community.

• What changes did you make in the BIOS? As making the changes in the BIOS is only recommended by Microsoft if done by the manufacturer.
  

• How are you connecting to the 2nd monitor?

I suggest you to follow the steps from this article below:

http://windows.microsoft.com/en-IN/windows-8/how-connect-multiple-monitors

[Applies to Windows 10 as well]

Regards.

 

Monitor problem - not waking up

Hey guys, I have an issue with my BenQ GW2765HT where if I turn on my computer with the monitor in standby (orange light) status the monitor will not wake up. I must then unplug the monitor from the AC power and then replug it and then also restart my computer before the monitor will wake up. This issue is intermittent however and also strangely if I do a restart from Windows the monitor goes to standby for a second or two before waking back up when the POST screen appears which is normal behaviour. So it seems only if the screen is on standby for some time does it fail to wake up again.

Also the monitor will not wake up if it is powered off (although still plugged in) under the same circumstances as if it were just on standby status and also requires the AC power to be disconnected and the computer to be restarted before it wakes up.

Any suggestions? Or should I just take it back to my shop?

info; I bought it in the middle of August last year.
edit; I am using a displayport cable. I've tried a different displayport cable and also with a different computer and I have the same problem. I also tried DVI and it happened more often.