Windows 10: No bios after installing win 10 pro

New build ryzen 5 5600 asrock b550 phantom gaming 4 win 10 pro. Perfectly installed windows without going to boot menu so I thought it wasn't an issue but after all updates and installing drivers I tried to go back to the bios through restarting to set xmp on the ram and all I get after pressing delete key is a black screen and vga/boot red light on my mobo any help would be greatly appreciated!

:)

 

access BIOS settings in Win 10

I have an 8-year old computer running Win 10. I need to access the BIOS settings. It used to be the holding down the F2 key during startup would bring up the BIOS screen in Windows computers. But this no longer works. A web article listed a complicated
series of steps leading to a reboot . . . but still no access to BIOS. Any suggestions?

 

bios

Hi all i am new in this forum, i need meanings step by step of each item listed in the bios Phoenix-Award

 

Reloading - retrieving my installed WIN 10 PRO

Thanks for the quick and detail response. Just to make sure I understand your procedure, here are the steps I will do:

1. Download Win10586PESE-x64 v16.07.07 (new) ISO and burn to a DVD.
   
   
   
2. Place DVD in computer and power ON boot from DVD
3. Run Macrium Reflect. Under the restore menu will be a utility to fix Windows startup problems. Try that utility to see if that restores booting to Windows 10
4. When Windows startup utility finishes, remove DVD and power OFF computer
5. Power ON and see if WIN 10 boots.
6. If WIN 10 boots, check for normal operation, etc.
7. If WIN 10 does not boot; re-install full WIN 7 disk image.
8. Download and save Windows 10 ISO file tofolder on C:\ drive
9. Down load and save:WinISO file on C:\ drive.
10. Run and install WinISO according to http://www.winiso.com/support/tutorials/mount-iso-in-windows7.html" target="_blank" rel="noopener">
    [*]Run WinISO, open the Windows 10 ISO file stored on C:\. I assume there will be some type of BROWSE menu so you can select the Windows 10 ISO file?
    [*] Click "Mount" and a file menu of the files in the Windows 10 ISO file will appear.
    [*]Double click to Run setup.exe.from the WINDOWS 10 ISO file menu
    [*]This should upgrade your Windows 7 to Windows 10 - This same procedure as the “Free” upgrade from WIN 7 PRO to WIN 10 PRO. When finished WIN 10 PRO will be installed and ALL WIN 7 PRO program files, drivers, printers and data files from WIN 7 PRO will be available for use. To be explicit this is an install of WIN 10 PRO and a “TRANSFER/ UPGRADE of WIN 7 PRO program files, drivers, printers and data files. This is NOT a CLEAN INSTALL of WIN 10 PRO
    

JUST WANT TO MAKE MAKE SURE I UNDERSTAND THE EXPECTED RESULTS

1. The newly created WIN 10 PRO install should activate based upon your previously activated upgrade. I assume the setup program will access some Microsoft data base and find my previous activation?

Please excuse the long list, but I find it better to ask questions now, rather than try to unwind some misunderstanding later.

I do appreciate your time and support!

Thanks