Windows 10: No Internet after resetting the router [Fix]

​

Resetting the router usually resolves many issues, but sometimes, it can create a few. We have noticed that after resetting the router, a wireless connection is created, but when a device is connected to it, it does not get any Internet. In this post, we will see what to do if there is no Internet […]

This article No Internet after resetting the router [Fix] first appeared on TheWindowsClub.com.

read more...

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

wireless conection to router

Hi,

To better assist you, we would like to know the following information:

• Are you able to see the router's name in the wireless networks list?
• Are you able to connect to the router but unable to connect to the Internet?
• Do you receive any error message when connecting to the router? If yes, what is the exact error message that you receive?

In the meantime, we suggest that you run the Network troubleshooter. The Network troubleshooter can help diagnose and fix common connection problems. Kindly follow the steps below:

• In the search box on the taskbar, type Network troubleshooter, and then select
  Identify and repair network problems from the list of results.
• Follow the steps in the troubleshooter and see if that fixes the problem.

If the issue persists, kindly try the troubleshooting steps on the following link:

Fix network connection issues in Windows 10.

We recommend that you try the steps on the Update the network adapter driver,
Run the Network troubleshooter followed by networking commands,
Temporarily turn off firewalls and Use network reset to reinstall network devices sections.

Let us know how it goes for us to assist you further.

 

Internet connection drops frequently, requires hard reset to fix

I don't think the router is at fault as you have mentioned that other devices working fine, I'm sure that you have the latest driver for your adapter, go to Device Manager, right click the adapter then select Properties, click Power Management tab, untick "Turn off this device to save power..." box.
You can also switch to Open DNS or google DNS, open Network & Sharing Centre, click your network, click Properties in WiFi status window(bottom left), highlight "Internet Protocol version IPV4..." and click Properties, change the DNS server as in my snip.
I'm using Opendns, if you want google dns, it's 8.8.8.8 Primary address and 8.8.4.4 Secondary.
I would suggest you to leave MTU settings alone for the time being.