Windows 10: NO SIGNAL on first boot, after restart it solves

So basically, every morning when I turn on the PC, the fans started spinning inside at a much faster rate with noise and RGB glowing, but I have no signal on the display and then the speed of the fans becomes normal After that, I have to press the restart button, then it boots up normally and I got the display and works like charm for the rest of the dayI have tried resetting the bios, updating the bios, and turning off fast boot, but no luck and facing this from 31st August 2024.

:)

 

Boot Process

Hi,

Please suggest me a link that can explain the boot process step by step of ...

• Windows 7,
• Windows 8.1,
• Windows 10,
• Windows Server 2008 R2 and
• Windows Server 2012 R2

With Regards

InTech

 

Boot problem ctr+alt+del no signal ...

Hi, I'm planning to continue the steps tomorrow night or sat night..

There something I would like to ask just now..
I was getting the boot errors again so I hit delete to enter the bios to check the boot order..

I noticed in the bios that the OS SSD is listed in the bios but it isnt listed in the boot order list, or I'm not sure if it is..
I have 4 options boot 1 to boot 4 in the list

Boot option 1 was my slave drive
boot option 2 was (I cant remember the letters exactly but were something like) uefi OS ? (I should have written them down.. is this the samsung ?
boot option 3 was my dvd rom drive
boot option 4 slave drive again..

I clicked on boot option 1 and wanted to choose the Samsung EVO 850 but it wasnt showing on the list to choose from.. I chose uefi OS (?) as boot 1 , unfortunately I got some more boot errors and after a few manual restarts Im now on the desktop..

Any advice on this ?

Next on the list from zbook is to run Run Sea Tools for Windows long generic scan and then the cmd commands which I will try for on fri night or sat..

Much appreciated..

 

HDMI no signal only during Boot

Hey Guys,

I've just built myself a new computer, all working well, however on boot my HDMI monitor receives no signal until Windows has fully loaded. It would receive signal to see the Bios screen pop up then go blank with no signal and then about 5 seconds later will receive signal and display the desktop.

I've now added a second monitor connected via DVI, even though this is not set as my primary monitor the bios screen displays on it and I can see the entire boot process through this monitor, it will then load to desktop of which a split second later my primary HDMI monitor will then receive signal and start to display.

It's not a massive issue but it's quite annoying, any suggestions?

I'm using a GTX 970 and Windows 8.1 Pro 64-bit.

Cheers,