Windows 10: No signal on monitor when I reset my pc.

I have checked if it is my monitors fault but the cable and the screen is working perfectly. It just says no signal, so I cant check if it is finished or not. Second time it is happening now.

submitted by /u/mr_the_europe
[link] [comments]

:)

 

Monitor not receiving signal from pc after using hdmi passthrough

Hi,

Thank you for writing to Microsoft Community Forums.

HDMI Pass-Through does not work with all devices. Before attempting to set up an HDMI Pass-Through connection, you should make sure the source of the signal such as a Blu-ray player or Set Top Box, supports HDMI Pass-Through.

In order to get clarity on this issue and assist you with appropriate troubleshooting steps, please reply with the answers to the questions below.

1. Did you try a different HDMI cable to connect your PC to the monitor?
2. When you say "my pc will not display to my monitor", are you able to see any error message on it? For example: 'No signal'.

Meanwhile, try the below suggestions and check if this helps.

• If your monitor has an option in the Menu Button to switch the
  Input Source to HDMI Port, I would suggest you to try it.
• Try completely disconnecting your Xbox from the computer and just connect your computer to the monitor and check if you are able to see the display on the monitor.
• Make sure your display is plugged in and turned on.
• Unplug the video cable from both your display and PC, and then reconnect them firmly. After you reconnect the video cable, try moving your mouse on your display.
• Try connecting to different video outputs on your PC. Sometimes a change in driver can cause the video to be sent to a different display adapter or output.
• If you have your own display adapter installed and connected to your display,
  try connecting your display to the built-in video on the motherboard.
• Check for damaged HDMI cable, loose connections, or faulty adapters.

Hope it helps.

We're looking forward to your response.

 

Windows 10 Update Installed & Now No Signal to Monitor

Hi,

For us to isolate your concern with your monitor's signal, we would like to know the following:

• When you say "signal", are you referring to the Internet?
• Are you getting any error messages? If yes, what is the exact error message?
• To make sure that we have not missed on anything, what troubleshooting steps have you done so far?

We look forward to your response.

 

INPUT SIGNAL OUT OF RANGE while playing Wizard 101

Hi,

Thank you for writing to Microsoft Community forum.

• Since when are you facing this issue?
  

This happens if the signal from the video adapter exceeds the scan range of the monitor. The video card is feeding the monitor a signal stream in excess of what the monitor can accommodate. The two main causes for this are that either the resolution
or the vertical frequency is set high.

You may try the troubleshooting steps listed in HP and Compaq Flat Panel Monitors - Flat Panel Monitor Displays Message about
No Signal, Signal out of Range, Sleep, or Power Save and check if it helps.

Regards,