Windows 10: No signal only on Advanced startup

Hi i have an issue that i can't go to advanced startup. I want to go to safe mode because i want to reset my gpu because i have a problem with my gpu so i'm using DDU. But when i try to go to advanced startup my monitor just turn black when i check, it say no signal what should i do my monitor work fine. I just can't get to advanced startup to go to safe mode so i can reset my gpu.

:)

 

Can't get GPU-Z to start with Windows 8.1 startup

I'm not sure how to do that. Could you list the steps for a noob?

 

Startup programs not launching on startup

Replying to Brink none of that works here is why- Step 1- No items listed in startup on task manager as stated. Step 2- I dont have shell:Startup on the pc as it cannot be located Step 3- I dont understand that option also the startup folder cannot be found Step 4- No apps showing under startup on settings Step 5- Dont have access to advanced options at all for any apps Step 6- Doesn't work. Thanks for trying - - - Updated - - - @dalchina, Will try the program now and no I have no suitable restore points and also nothing that I am aware of has been updated besides for Windows Updates but nothing major. WIll respond once I try the program.

 

windows 10 no advanced-startup-options, so no startup settings

when i did 1. 2. 3. steps i checked and problem was SOLVED
but after 4. 5. 6. 7. steps i checked and no advanced startup options again

1. Make a complete backup image of your current HD including all partitions to an external HD using macrium reflect . Once done, disconnect all USB devices from the PC. Assuming now you only have one HD connected to the PC which you will be installing Windows.
   IMPORTANT: Also create a Macrium Rescue disk to boot from later on.
2. Boot up your Windows installation USB/DVD. On the first screen, Hold SHIFT + F10 to open Command Windows then type:
   Diskpart
   select disk 0
   clean
   exit
3. Click Next, Choose Custom, select the unallocated partition then click Next (Do not format), when asked for Product ID key, click on "Skip this step"/"Do it later". Continue the Installation.
4. Once done. With the external HD connected, Reboot your PC with the Macrium Rescue disk, select the image that you created in step 1 as the Source.
5. Select your current HD/SSD as Destination disk
6. Restore only C: Drive to it. ie. overwrite the new C: Drive with your backup C: Drive.
   NOTE: See screen shot on how to perform this step
7. Disconnect all the external devices. Reboot. Windows should perform a startup repair.

till 4. step there was no windows 10 key activeted and problem vas solved
but after step 7 i checked key and it was not the same which i purchased, why did that change? i activated purchased key again.
so is the problem to be a windows 10 key on my pc?
or do some drivers prevent advancedstartup options?