Windows 10: No video signal after resetting BIOS to standard settings

Hi.A while back I encountered a problem where my system wouldn't boot to windows. For some reason I was also unable to for example load an earlier restore point, or as I've had to do several times earlier use my bootable USB installation media to boot/repair the installation.I don't remember exactly why I tried this next but I went into BIOS and choose to return it to its standard settings after which I saved and rebooted the system.Ever since then I'm unable to receive a signal from my graphics card RTX 2060 Super, either to my monitor or my TV. I've tried both Hdmi and DP. Unfortunately

:)

 

xbox 360 splitting video signal

Hello,

I just happened to come over your post.

Could you please tell us exactly where you don't get any signal? Both the screen and the computer (via capture device)?

Have you tried the following?

• Make sure you get a signal to the screen when using an HDMI cable directly from the Xbox 360 to the screen. Please make sure all cables work.
• Make sure you get a signal to the capture card with the same cables.

If you get a signal on the screen but not on the computer, could you please try the following?

• Set the Xbox 360 to output at 720p. The frame rate will (or should) be 59.94.
• If possible, make sure you capture the video with the same settings on the computer.
• Try any other settings if this does not work.

If it still does not work, please try this in the same order:

• Power off computer (and capture device) and Xbox 360.
• Power on computer (and capture device) and wait until the capture device is properly powered on and initialized.
• Power on the Xbox 360.
• Make sure you can capture properly.

If it still does not work, make sure that one or more of the following are not defective:

• The HDMI-VGA/composite adapter.
• The VGA cable.
• The capture device (could be just the input connector).

If that works, please install the HDMI splitter.

I am wondering a bit why you show us the wires inside the HDMI cable. Did you remove the isolation and/or do something with the wires?

I am not sure what else to suggest at the moment.

Could you please tell me/us the model of your capture device, and also the adapter between the HDMI cable and capture device?

Regards,
awd_

 

access BIOS settings in Win 10

I have an 8-year old computer running Win 10. I need to access the BIOS settings. It used to be the holding down the F2 key during startup would bring up the BIOS screen in Windows computers. But this no longer works. A web article listed a complicated
series of steps leading to a reboot . . . but still no access to BIOS. Any suggestions?

 

bios

Hi all i am new in this forum, i need meanings step by step of each item listed in the bios Phoenix-Award