Windows 10: No WiFi connection option just ethernet

I have been using an ehermet cable for a while but today I tried going back to WIfi and it doesn't scan for connection s. I've tried device manager to check problems and update drivers. I've reset the adapter settings back to factory, I I've reset my router but still doesn't do a WiFi scan. I've looked at the same question on here and I tried the replies to that and got nowhere .Any help would be greatly appreciated

:)

 

Make Windows 10 connect/disconnect to WiFi based on Ethernet connection status

Steps:

1. Go to Control Panel\ All Control Panel Items\ Network and Sharing Center > click on 'Change adapter settings' then use the 'alt button' to show menus and select Advanced Settings...
   
2. Under Connections section, select Ethernet, and use the arrows to the right to move Ethernet above WiFi.
   
3. Click OK.
   

Windows will now prefer the Ethernet over the WiFi for connecting to the internet. This should apply for Windows 8, 8.1, and 10.

 

Bridging wifi and ethernet connections – wifi keeps disconnecting

Hi all,

I am trying to use Windows to bridge my wifi connection to non wifi devices. I have successfully setup the bridge in Network Connections. However, the wifi only stays connected for a few seconds before it disconnects (everything is working as expected, with wired devices having internet access, until wifi disconnects). This seems to be something to do with the ethernet cable being connected, as when I disconnect the ethernet the wifi stays connected.

Things I have tried:

• Turning off power management and checking bios for any funky power management settings
  
• Setting "Priority & VLAN" to disabled
  
• Disabling "Automatic metic" and setting wifi to priority order – though you don't seem to be able to change this for specific connections when bridged.
  

Any suggestions greatly appreciated.

P.S. everything works fine with bridge disabled and using internet connection sharing enabled on the wifi. However I am unable to connect to devices such as printers (hence why I am trying bridged mode).

 

No options to connect with wifi, only ethernet

I'm trying to install my windows on my new ssd. When I'm trying to connect with my network settings it only allowed me to connect with Ethernet and no options for wifi.