Windows 10: "Not enough memory resources are available to process this command" when trying to connect...

Hello everybody.


I have a wi-fi modem in wich i can connect a usb drive and access it from Windows explorer in my PC.

The thing is that when i enter the link (\\192.168.2.1\Expansion Drive) i get this message:

\\192.168.2.1\Expansion Drive is not accessible. You might not have permission to use this network resource. Contact the administrator of this server to find out if you have access permissions.

Not enough memory resources are available to process this command.


I have an administrator account.


I have seen a lot of posts about "Not enough server storage is available to process this command" but is not the same message i get.

I tried too adding the IRPStackSize parameter in the registry (HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\lanmanserver\parameters) with a value between 10 and 50 and nothing works.


My PC's information:




Any of you have any idea(s) please.


Thank you

:)

 

GPU-Z what command line parameter ?

Suggestion: /? (-?) and /help (-help) command-line arguments to show a list of all possible arguments in a small window. *Smile

 

"Not enough memory resources are available to process this command."- Command Prompt offline

The noted message is only displayed for the offline command prompt, oddly enough.

The reason I want to run it is because after a weeks endeavour fighting a possible infection, windows finally caught "Trojantrojan:win32/Bitrep.B", and after cleaning it up, I ran sfc /scannow (on windows), which found and repaired a mega list of corrupted/missing/etc.
files, so now I want to follow it up with an offline scan, but i can't...

What should I do?

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".