Windows 10: nslookup not giving streight awnsers with vpn

ok guys this is with my vpn , i do not get any nslookup returns

C:\WINDOWS\system32>nslookup sag.com
DNS request timed out.
timeout was 2 seconds.
Server: UnKnown
Address: 192.168.1.1

DNS request timed out.
timeout was 2 seconds.
DNS request timed out.
timeout was 2 seconds.
DNS request timed out.
timeout was 2 seconds.
DNS request timed out.
timeout was 2 seconds.
*** Request to UnKnown timed-out
C:\WINDOWS\system32>ipconfig /all

here is the ipconfig with vpn

Windows IP Configuration

Host Name . . . . . . . . . . . . : Ghosty
Primary Dns Suffix . . . . . . . :
Node Type . . . . . . . . . . . . : Hybrid
IP Routing Enabled. . . . . . . . : No
WINS Proxy Enabled. . . . . . . . : No

Wireless LAN adapter Wi-Fi:

Media State . . . . . . . . . . . : Media disconnected
Connection-specific DNS Suffix . :
Description . . . . . . . . . . . : Dell Wireless 1704 802.11b/g/n (2.4GHz)
Physical Address. . . . . . . . . : 2C-33-7A-FC-D3-69
DHCP Enabled. . . . . . . . . . . : Yes
Autoconfiguration Enabled . . . . : Yes

Wireless LAN adapter Local Area Connection* 2:

Media State . . . . . . . . . . . : Media disconnected
Connection-specific DNS Suffix . :
Description . . . . . . . . . . . : Microsoft Wi-Fi Direct Virtual Adapter
Physical Address. . . . . . . . . : 2E-33-7A-FC-D3-69
DHCP Enabled. . . . . . . . . . . : Yes
Autoconfiguration Enabled . . . . : Yes

Ethernet adapter Loaded:

Connection-specific DNS Suffix . :
Description . . . . . . . . . . . : Realtek PCIe FE Family Controller
Physical Address. . . . . . . . . : 74-E6-E2-3F-B1-5C
DHCP Enabled. . . . . . . . . . . : Yes
Autoconfiguration Enabled . . . . : Yes
Link-local IPv6 Address . . . . . : fe80::cc02:ece8:676d:670b%7(Preferred)
IPv4 Address. . . . . . . . . . . : 192.168.1.20(Preferred)
Subnet Mask . . . . . . . . . . . : 255.255.255.0
Lease Obtained. . . . . . . . . . : Sunday, 3 September 2017 18:58:37
Lease Expires . . . . . . . . . . : Monday, 4 September 2017 18:58:37
Default Gateway . . . . . . . . . : 192.168.1.1
DHCP Server . . . . . . . . . . . : 192.168.1.1
DHCPv6 IAID . . . . . . . . . . . : 57992930
DHCPv6 Client DUID. . . . . . . . : 00-01-00-01-1C-55-4F-58-74-E6-E2-3F-B1-5C
DNS Servers . . . . . . . . . . . : 192.168.1.1
NetBIOS over Tcpip. . . . . . . . : Enabled

Ethernet adapter Ethernet:

Connection-specific DNS Suffix . :
Description . . . . . . . . . . . : TAP-Windows Adapter V9
Physical Address. . . . . . . . . : 00-FF-33-33-8A-DA
DHCP Enabled. . . . . . . . . . . : Yes
Autoconfiguration Enabled . . . . : Yes
Link-local IPv6 Address . . . . . : fe80::9928:bddf:94e2:29dd%31(Preferred)
IPv4 Address. . . . . . . . . . . : 10.10.110.74(Preferred)
Subnet Mask . . . . . . . . . . . : 255.255.255.252
Lease Obtained. . . . . . . . . . : Sunday, 3 September 2017 19:06:59
Lease Expires . . . . . . . . . . : Monday, 3 September 2018 19:06:59
Default Gateway . . . . . . . . . :
DHCP Server . . . . . . . . . . . : 10.10.110.73
DHCPv6 IAID . . . . . . . . . . . : 520159027
DHCPv6 Client DUID. . . . . . . . : 00-01-00-01-1C-55-4F-58-74-E6-E2-3F-B1-5C
DNS Servers . . . . . . . . . . . : 10.10.100.1
NetBIOS over Tcpip. . . . . . . . : Enabled


when im not running vpn i get this
C:\WINDOWS\system32>nslookup sag.com
Server: unknown
Address: 192.168.1.1

Non-authoritative answer:
Name: sag.com
Address: 63.236.8.13

ive got tomato advance loaded onto my router and have vpn running through that for external items like mobile phones and laptops but my pc is not apart of the vpn as the router slows the link speed down so i use the client alone on my pc
when using vpn with external devices it reverts back to my isps dns so ive changed dns too dnscrypt servers on manual dns , which for external devices it uses that dns
need some help figuring this problem out , when using vpn on my pc alone all my dns queries take forever to lookup , the external devices are fine.

tried all these ideas

Reset WINSOCK entries to installation defaults : netsh winsock reset catalog
Reset TCP/IP stack to installation defaults : netsh int ip reset reset.log
Flush DNS resolver cache : ipconfig /flushdns
Renew DNS client registration and refresh DHCP leases : ipconfig /registerdns
Flush routing table : route /f (reboot required)

thanks

:)

 

NSLOOKUP and PING do not match

I read many articles about the different results between nslookup and ping, but I somehow feel I do not fit in any of the explanations.

Scenario: Windows 10 (latest updates) connected to a corporate VPN via SSTP. The VPN connection is configured to suffix the corporate domain on the DNS queries (but on my tests I experimented removing and adding this). My hosts file is empty,
except the comments that comes by default. I did a flushdns just before the commands.

On the server side there is a corporate webserver with specific rules when the connection originates from the internal LAN (or VPN) or from the WAN. The correct behavior was already observed in the past, so this "works". Next steps is experimenting other
machines.

Use Case:

• With the VPN connected, nslookup will use the LAN's Default Server and not my ISP DNS -> OK
• NSLOOKUP a certain fully qualified host name will give me it's internal LAN address -> OK
• PING the same fully qualified host name will give me the public WAN address of the corporate domain -> Not OK, unless the VPN is disconnected, in that case de results would be OK.

Opening a browser with the same fully qualified host name goes into the WAN access limited page (load balancer rules detecting the origin remote address), although the client host (my PC) is in the LAN via VPN. Using chrome's "net-internal" page I see the
browser is resolving the WAN address instead of the LAN address (item 2 above).

Again, I know ping and nslookup do not resolve names exactly in the same manner, but there is no DNS cache and the hosts file is clean, I would still expect ping to resolve the internal LAN address in this case.

Any ideas on further troubleshoot why the browsers seems to be resolving the names incorrectly?

Note; It may be me, but this latest windows 10 upgrade/update seems to have broken the network. Just a gut feeling from some glitches in the last weeks.

 

Problem with Internet & LAN access after update - Version 1703

What are you DNS servers set to?

ipconfig /all should show your servers.

also, if you could run the nslookup command with the server you are trying to resolve

example:

nslookup microsoft.com

should give output similar to the following

Non-authoritative answer:

Name: microsoft.com

Addresses: 23.96.52.53

191.239.213.197

104.40.211.35

104.43.195.251

23.100.122.175

Tripp

 

im running win ten creators update..

ok heres with another vpn running
this one has LOCAL on DNS suffix yet the other vpn i use does not have this..yet this one does nslookups..


Connection-specific DNS Suffix . : local
Description . . . . . . . . . . . : TAP-Windows Adapter V9
Physical Address. . . . . . . . . : 00-FF-D3-AA-B9-BC
DHCP Enabled. . . . . . . . . . . : Yes
Autoconfiguration Enabled . . . . : Yes
IPv6 Address. . . . . . . . . . . : fd25::1(Preferred)
Link-local IPv6 Address . . . . . : fe80::11b8:e3f8:9c37:92f5%5(Preferred)
IPv4 Address. . . . . . . . . . . : 10.0.104.130(Preferred)
Subnet Mask . . . . . . . . . . . : 255.255.255.128
Lease Obtained. . . . . . . . . . : Sunday, 3 September 2017 21:14:58
Lease Expires . . . . . . . . . . : Monday, 3 September 2018 21:14:58
Default Gateway . . . . . . . . . : fe80::8%5
DHCP Server . . . . . . . . . . . : 10.0.104.254
DHCPv6 IAID . . . . . . . . . . . : 83951571
DHCPv6 Client DUID. . . . . . . . : 00-01-00-01-1C-55-4F-58-74-E6-E2-3F-B1-5C
DNS Servers . . . . . . . . . . . : 10.10.10.12
10.10.11.12
10.10.12.12
NetBIOS over Tcpip. . . . . . . . : Enabled

nslookup google.com
Server: dns.cypherpunk.com
Address: 10.10.10.12

Non-authoritative answer:
Name: google.com
Addresses: 2404:6800:4006:804::200e
172.217.25.142