Windows 10: ntoskrnl running at 100% od disk

ive ran in safemoide and changeds startup programs and is still does it thanks to anyone who can help

:)

 

Disk Usage at 100% with nothing running

My PC is running Windows 10 with the latest updates but has suddenly become unusable with disk usage staying at 100% even with nothing running and just the same processes listed in Task Manager as before the problems
started. I've tried a few suggestions found in online forums - disabling Windows Search and Superfetch, adjusting page file size, etc. but nothing has done the trick yet. I don't have any outside anti-virus software installed. I read about the potential MSI
issue but don't have IDE ATA/ATAPI Controllers listed in the Device Manager. Finally, it seems to boot up normally and will have periods where the disk usage drops and it's usable but those moments are brief and it inevitably goes back up to 100% usage.

 

Clean install, disk usage at 100%

I've seen that article. and I am in fact not running that driver. I followed the steps and it does not appear in the list.

 

Disk is always at 100%

Hi Richard,

Some bugs or disk drive errors may cause high disk utilization. If your task manager shows 100% disk utilization, you may need to optimize Windows by following these troubleshooting methods:

Disable Windows Search

Some bug in Windows 8, 8.1 and 10 causes some "search loop" that causes maximum utilization of your disk. To disable
Windows Search, kindly follow these steps:

• Press Windows + R to open Run.
• Type services.msc and press Enter.
• Scroll down to find Windows Search, right-click it, and select
  Properties.
• Change the Startup type to Disabled and save the changes.

Disable Superfetch Service

Superfetch service has been identified as a possible cause of 100% disk utilization on Windows 10. To disable Superfetch service, kindly follow these steps:

• Press Windows + X and select Command Prompt (Admin).
• Type net.exe stop superfetch and press Enter.
• Wait for a minute for the changes to apply and close the Command Prompt.

Let us know how things goes.

Regards.