Windows 10: NuVision Solo 10 tablet stuck in upgrade loop

I have a NuVision Solo 10 (model # TM101W610L) that is stuck in a loop while doing the October upgrade.


It boots up, the Windows logo displays, then the spinning dots start, and after about 20 - 30 seconds I get the message "Undoing changes made to your computer...". After 4 - 5 minutes it restarts, and the whole thing repeats. This will go on for hours, until I do a hard shutdown.


This device only has 32GB of internal storage, so I have a 128GB micro SD card installed. The card had about 100GB of free space before the upgrade started.


I have tried removing the SD card, but then I get an error message telling me that the card needs to be reinstalled.


Any ideas of what to try?

:)

 

Keyboard on Nuvision tablet

Hi Tim,

The concern you have encountered may be due to a corrupted file or a misconfigured setting. In this case, we suggest you run the hardware troubleshooter to check scan the device check and repair the concern. To do this, simply follow the steps provided by
SujataMoktan on this
link.

You can also try turning on the tablet mode on Windows 10 to see if it helps.

If you require any further information, feel free to let us know.

Regards.

 

Nuvision TM800 Reset loop

Hello,

After updating my Nuvision TM800 to the fall creators update I was forced to try to reset the tablet to get functionality of many apps and the app store, now I am stuck in a failure loop. The loop runs from 64% complete up to approximately 70% where it shows
a garbled Error screen and then resets back down to 64%.

It has been doing this for a while now.

I've tried holding the power and lower volume buttons, but it just brings it to the 64% complete spot.

Any ideas on fixing this.

Thanks,

Mark

 

nuvision tablet!!!!

Would like to know how to turn on Nuvision tablet,it shut off & can't restart?????