Windows 10: Odd graphical errors with the new updates

I've started noticing an odd graphical error when I start up my computer and I'm not sure what's causing it. I can't give an example cause it goes away after I turn my monitor off and back on again (although because of the connector type this also disconnects and reconnects the monitor). It only occurs on my second monitor. The error is about halfway along all spectrums of colour where certain pixels turn blue or something like blue. The computer is a few years old as are the monitors and is running the latest version of Windows 10 with the latest nvidia drivers. Please ask if there's any more info you need

submitted by /u/Eskoot195382
[link] [comments]

:)

 

Cannot find enough free resources to run graphics card after windows 10 update

Hi Tom,

It's odd that the update causes an issue with the graphic cards on your computer. The compatibility of your driver could be the culprit here. We suggest that you update your graphic cards driver in Device manager. Here are the steps on how to do so:

• Click the Start menu, then search for Device Manager.
• Expand the cate3gory for your graphic card/s, then right-click on it and choose
  Properties.
• Go to the Driver tab, then click on Update Driver.
• Select Search automatically for updated driver software.

Note: If Windows doesn't find a new driver, you can try looking for one on the manufacturer's website of your graphic card.

 

Graphics card information.

Hi David,

Thank you for posting your query in Microsoft Community. Appreciate your interest in using Windows 10.

The error might occur if the Graphic card is cannot update the driver automatically.

I suggest you to update the graphic card manually by following the steps below:

• Press Windows key + X and click on
  Device manager.
• Expand Display Driver from the list.
• Right click on the Graphic driver and select
  update driver software.

Also, can download the latest version of the graphic card from the manufacturer website.

Hope the information is helpful. Please revert back with the necessary information and we’ll be glad to assist you.

 

Intel Readies P55 Chipset B3 Stepping Update

Intel's is readying a hardware update for its P55 Express chipset, currently the only core-logic for the company's brand new socket LGA-1156 processor platform. The new B3 stepping of the P55 PCH will bring with it a little more than new MM number and S-spec numbers. A list of changes is as follows:

• New MM number and S-spec numbers for the converted products;
• Firmware and minor BIOS updates are required with the conversion;
• Processor MRC/microcode update required to enable future processors;
• Recommended storage driver upgrade from Intel MSM 8.9 to Intel RST 9.5.

Although it is listed that the MRC update enables 'future processors', Intel, in a statement issued to X-bit labs assured that the current B2 stepping of the chipset (found on current socket LGA-1156 motherboards) does not leave out support for any of Intel's new LGA-1156 processors that are slated for release in the very near future. The dual-core "Clarkale" 32 nm processor will be supported by both B2 and B3 steppings of the chipset.

P55 B3 stepping is pin-identical to P55 B2, and hence motherboard vendors will not have to come up with new designs. Sampling of the new stepping began as early as on October 02, 2009, and it is scheduled for shipment to manufacturers by the 7th of December, 2009. P55 is the performance core-logic for the LGA-1156 platform. It supports Core i5 and Core i7 "Lynnfield" processors with discrete graphics.

Source: X-bit labs