Windows 10: Ok after navigating from command prompt x admin loop I selected disk part and "disk2"t of...

Now what do i do going forward at the x admin black windows and the DISKPART prompt.

:)

 

Disk management console view is not up-to-date

i dont know how to fix your disk management, but i can fix your partition problems...




open up Command Prompt with admin rights. (Right click, run as admin)


enter in
DISKPART
list disk

then find the Disk number for your Raid array... lets call it number 7 ( you can tell what disk is what by the total size)
type in

Select Disk 7
List Partition (will give you a list of all the partitions..)
Select Partition 1 (im assuming you only have 1 partition on Disk 7) repeat this step if you have more partitions.
ASSIGN


that should get the array up and running ready to use.


EDITED.

any problems, post back ^^


Still EDITING *Stick Out Tongue

side question, have you tried restarting the PC?

 

command prompt is x:\windows\system32

My computer crashed and I have tried everything I can think of you restart, but the command prompt starts with x: instead of c: I've tried the fixes suggested and listed below:

In Command Prompt, type DISKPART, press Enter.

When it loads type LIST DISK.

Choose the Windows hard drive by typing SEL DISK # with # being the desired disk number from results.

Then type LIST VOL which will provide a list of the various partitions with their assigned drive letters in Recovery mode which may be different than in Windows.

But when I type in DISKPART is says There are no disks to show

Any ideas?

 

Command prompt boot, which disk to select





I have a question i m trying to boot my computer using COMMAND Prompt:

It start as

Microsoft windows [version 10.0.16299.125]

x:\Sources

I typed “disk part”

it shows

Copyright (c)

mocrosoft corporation.

On computer: MININT-U85VH7A

Diskpart > list disk

than it shows

Microsoft disk part version 10.0.16299.15

and a long list that start with

I attached a picture of it please help