Windows 10: Old HDDs not appearing in Disk Managment using adapter

So I have some old HDDs from older computers that i am trying to view the files for. I bought a SATA/IDE to USB adapter, but when I connect it I dont see any of the drives in Disk Management or file explorer. Its connected correctly and I can hear the HDD spinning. Im afraid maybe they are too old and not compatible with the newer version of windows 10. Can anyone help me please?

:)

 

HDD in a HDD caddy is not showing up in the disk management

Hi,

To assist you better, I would like to ask some questions:

• How are you connecting the HDD Caddy?
• What is the make and model of your computer?

If you are connecting the device using USB, I suggest you to check if other USB devices are recognized as USB devices or Other device. If it is displaying as other device, then the issue might be with the USB port. So, I suggest you to update the USB drivers
by following the steps below:

• Press Windows key + X, select Device Manager.
• Expand Universal Serial Bus Controller.
• Right click on the drive, select Update Driver Software and follow the on-screen prompts.

Keep us posted on the status for further assistance.

 

Wireless adapter not found in Device Manager

I ran the Lenovo Solution Center. Network Adapter was not listed in the hardware scanned. Not sure if there is a separate listing for that normally or not.

Ever since I ran a power cycle the adapter has not appeared in the Device Manager.

Does anyone believe removing the adapter and putting it back would solve the issue? I would rather not open my computer if there is little chance of it solving the issue. I am a complete novice doing this.

Not sure if this is relevant but in my Network Adapter in Device Manager there was "Microsoft Kernel Debug Network Adapter". It has since disappeared.

 

Disk management console view is not up-to-date

i dont know how to fix your disk management, but i can fix your partition problems...




open up Command Prompt with admin rights. (Right click, run as admin)


enter in
DISKPART
list disk

then find the Disk number for your Raid array... lets call it number 7 ( you can tell what disk is what by the total size)
type in

Select Disk 7
List Partition (will give you a list of all the partitions..)
Select Partition 1 (im assuming you only have 1 partition on Disk 7) repeat this step if you have more partitions.
ASSIGN


that should get the array up and running ready to use.


EDITED.

any problems, post back ^^


Still EDITING *Stick Out Tongue

side question, have you tried restarting the PC?