Windows 10: OPTIMIZAR SSD

Solía usar la herrmienta que da windows para optimizar y desfragmentar mi SSD y mi disco duro, pero he leído varios artículos que dicen que desfragmentar un SSD puede acortar su tiempo de vida. Pero también leí que windows una vez que detecta un SSD desactiva la desfragmentación por lo que no lo afecta en nada. Quisiera saber si me pueden resolver esta duda que tengo.

:)

 

SSD Crucial Bx 100 - rattling/vibrating. Possible?

This has been suggested several times already, and it has been suggested you try to move the SSD, remove it, or even suspend it in your case. Will you please try one of these?

If you don't understand vibration and resonance, please refer to @dorsetknob 's post above. *Smile It has been explained that something else moving/vibrating (even if you don't think they're vibrating they are...), fans, hard disk drives, and anything with a motor will cause some form of vibration at certain frequencies. This can be transfered through your case's chassis and where you mounted your SSD could be reaching a certain frequency that causes it to slightly move and rattle against the case.

We are suggesting you take action and report back..you keep asking questions from step 1...we should be on step 4 by now...that is solution.

Try what has been suggested and report back please. Otherwise all you're doing is leading this thread in an endless circle and the help will stop shortly thereafter.

*Toast :toast:

 

Cloning to SSD then swapping drive letters


@SamHobbs
What you want done is very simple and can be done in short period of time. Here's my suggestion:
There's 2 modes that Windows can be installed: UEFI and the old legacy MBR. Open Disk Management, look at the disk where your C drive is, if there's a

1. EFI System Partition, your Windows was installed using UEFI.
2. System Reserved partition, your Windows was installed using MBR

Next, Connect your SSD to an available Sata port (no need to format or do anything). Download: Macrium Reflect Free . Install and run. Follow the steps below:

1. From Macrium, click on image this disk under your C drive and save it to either an Internal or External Drive. This will create a single backup image of the whole disk containing your C drive.
2. Again, from Macrium, click on Restore tab and select the image created from step 1, Select your SSD as the destination drive, click Next->Finish
3. Exit Macrium. If your Windows was installed using MBR, Open disk management and make sure the SSD is marked "Active" else go to next step.
4. Shutdown your PC. Disconnect the HD containing Windows C drive then connect your SSD to it.
5. Reboot. Your PC should boot and the Windows should have C as the drive letter.

NOTE: The procedure above is to backup your Windows to an image file then copy it back to the SSD. This ensures proper cluster size aligment for the SSD. In addition, Macrium also perform Trimming for the SSD. This is more preferable than cloning.

 

Windows 10 SSD Boot and Sleep faliure

Windows cannot stop the BIOS recognising the SSD. If at any time you can go into the BIOS and the SSD is not listed then you have an (intermittent) hardware fault. It does not matter what the precursor steps are if the hardware was OK it must be listed

Step 6 is categorical, you have a hardware fault. BIOS device recognition is always before drivers load so they cannot affect the process