Windows 10: Osama Ali Question on How to Rename /Renumber partitions Aomei VS windows

It's best to use all Aomei tools. Use Aomei Backupper 6,8 not 6.9 to create a new WINPE environment called Aomei Recovery using tools menu. Partition Master 9.8 and you can still get Onekey Recovery 1.6.2 Free. Unless You Pay you can purchase the latest versions. Aomei writes new system and boot files and into your BIOS which assigns drive letters as each won is created so it can find its files. It often comes preinstalled with Lenovo, HP and other computers. WINRE is completely changed. IT is easy to set up free version and its fail safe. You can't not mix up WINRE with windows disk managemen

:)

 

how to renumber partitions

Dear Sir/Madam

Hello

a friend of mine has UEFI windows 10 21H2,

disk0 partitions layout were System , MSR , Windows , Recovery , "D" Partition , "E" Partition,

Recovery was Partition number 4, "match location sequence"

He asked me to reduce windows partition size from 2 TB to .5 TB, I did that with third parity program AOMEI,

AOMEI made the changes and for unknown reason changed Recovery partition ID, So System didn't recognize the partition as a recovery partition,

I deleted the partition, and recreated again with the correct parameters and reconfigured Recovery environment successfully,

but recovery partition became number 6, it's located after windows partition number 3 but became number 6,

UEFI layout became System (1) , MSR (2) , Windows (3) , Recovery (6) , "D" (4) , 'E" (5),

is there any way to get back number 4 for Recovery ? without losing data for windows partition , "D" partition and "E" partition?

In brief how to renumber partitions according to it's correct sequence?

Thank you

Osama Ali

 

The Aomei Partition Manager

Is Aomei Partition Assistant safe to use?

I have seen previous posts about problems with safe mode, too.

If you suggest a different software, please link me.

Thanks, Dare

 

W7 Hard drive partition issue

to get rid of that 100 meg windows partition that setup creates for you on a new install on a blank hdd:

- press shift+f10 when on the partition management screen in setup <-- this opens a command prompt
- diskpart <-- start the windows command line partition management tool
- list disk <--- list the installed hdds in this computer for the next step
- select disk 0 <- might have to replace 0 with the number of the correct disk
- clean <-- this will erase all data on the disk you selected one step up- dont use the wrong disk!
- create partition primary <- creates a primary partition taking up all space on the drive, adjust the command if necessary
- exit, exit to exit diskpart and the command prompt
- click refresh in partition manager and select your newly created partition and install to that