Windows 10: outlook format change

Hello, so I somehow managed to change my screen layout in outlook and I don't know how and can't figure out what I did. it is just at the inbox. I get this abbreviaterd look that I don't understand why I would want, all other folders are still normal. see attached snips. version 19041. I am confused as to what I even did. Ideas ??

Ken

:)

 

Changing Time Format

Hi Mary,

There's a possibility that the set up time format in your computer Basic Input/Output System (BIOS) is military time. To have this checked, you can try to reset the time of your computer through Control Panel. See the steps below on how to do
so:

• Open Control Panel > Clock, Language, and Region >
  Change date, time, or number formats. This would open the
  Region window.
• From there, click on Additional settings at the bottom part. It will open the Customize Format.
• Click Reset; then, OK.

The steps should work; however, if not, we suggest that you contact manufacturer and have the BIOS time checked.

Let us know what happens after doing the suggestions .

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!

 

Outlook 2013 change my system date format

Hi,

Thank you for writing to Microsoft Community.

It seems that outlook is deleting the registry value. Here are few steps that you can try:

Method 1: Please follow the instructions provided in the article:
Change the date system, format, or two-digit year interpretation

Method 2: I would request you to add a registry value to Windows Registry.

1. Open Command Prompt and run it as Administrator.
   
2. Type the following command: reg add "HKCU\Control Panel\International" /f /v sShortDate /t REG_SZ /d "dd/MM/YYYY" >nulecho %date%
   
   
3. Close the Command Prompt and restart your device. The date should be in the format now.
   

Note: Important this section, method, or task contains steps that tell you how to modify the registry. However, serious problems might occur if you modify the registry incorrectly. Therefore, make sure that you follow these steps carefully. For added
protection, back up the registry before you modify it. Then, you can restore the registry if a problem occurs.

How to back up and restore the registry in Windows.

Regards,