Windows 10: Partition got bitlocker after windows download

After downloading a windows version to my laptop one partition got bit locker and i couldn’t open it

:)

 

W7 Hard drive partition issue

to get rid of that 100 meg windows partition that setup creates for you on a new install on a blank hdd:

- press shift+f10 when on the partition management screen in setup <-- this opens a command prompt
- diskpart <-- start the windows command line partition management tool
- list disk <--- list the installed hdds in this computer for the next step
- select disk 0 <- might have to replace 0 with the number of the correct disk
- clean <-- this will erase all data on the disk you selected one step up- dont use the wrong disk!
- create partition primary <- creates a primary partition taking up all space on the drive, adjust the command if necessary
- exit, exit to exit diskpart and the command prompt
- click refresh in partition manager and select your newly created partition and install to that

 

BitLocker won't enable on Windows 10 after update on Aug 9

Hi Brenda,

I would be happy to assist you.

Before I assist you I would like to know the information below,

• 
  Do you have a Windows 10 copy of the operating system?
  

I suggest you check whether the Bit locker is ON or OFF using the steps below.

Can you verify if BitLocker is enabled or disabled on your device? You can Enable/disable BitLocker by going to Desktop and follow these steps:

• 
  Swipe Right to Left to bring up the Charm.
  
• 
  Choose Settings.
  
• 
  Choose Control Panel.
  
• 
  Select BitLocker Drive Encryption.
  
• 
  Verify whether BitLocker is on or off on each device.
  

Also I suggest you to enable the WinRE so that you can enter the bit locker key and proceed.

When WinRE is disabled, you cannot enable BitLocker, and you receive an error message that resembles the following.

This PC doesn't support entering a BitLocker recovery password during startup. Ask your administrator to configure Windows Recovery Environment so that you can use BitLocker.

The solution would be to manually enable the windows recovery environment:

• 
  Copying the winre.wim file from c:\windows\system32\recovery\ to a folder on a recovery partition. (The partition need to have a drive letter at this point.)
  
• 
  Set the RE Image path. Example: reagentc /setreimage /path r:\recovery\windowsre
  
• 
  Enable RE with command: reagentc /enable
  
• 
  (You may remove the drive letter for the recovery partition after you have done this.)
  
• 
  Bit locker will be enabled.
  

If the issue still persists, suggest you to post your query on the below link.

https://technet.microsoft.com/en-us/library/hh831507(v=ws.11).aspx

Hope this information was helpful and do let us know if you need further assistance. We will be glad to assist.

Thank you.

 

Need to turn off Bitlocker to install Windows 10

Hi,

We suggest doing the following steps again to resolve the issue. To complete the procedure, make sure that you have the following information:

• You must be able to provide administrative credentials.
• The drive must be BitLocker-protected.

To suspend BitLocker Drive Encryption on an operating system drive, please follow the steps below:

• Click Start, click Control Panel, click
  System and Security, and then click BitLocker Drive Encryption.
• Click Suspend Protection for the operating system drive.
• A message is displayed, informing you that your data will not be protected while BitLocker is suspended and asking if you want to suspend BitLocker Drive Encryption.
  
• Click Yes to continue and suspend BitLocker on the drive.

Let us know how it goes.