Windows 10: Partition problems:

My computer was running, dual boot.With Windows 10, and Windows 11.But I decided to run, only Windows 10.As you can see, in the picture.C: is, the primary partition.It's running, Windows 11 right now.And then there's, the other partition. 471.70 GB What I want to do, is remove that space.And install, Windows 10. On a, "single" partition.That's, my problem. I did delete, the volume.But shrink or expand, is not available.So either way, I don't know what to do?Does anyone know, how to create.That single, partition? There has to be, a way!Hopefully someone, will have the answer?Thank you, for re

:)

 

W7 Hard drive partition issue

to get rid of that 100 meg windows partition that setup creates for you on a new install on a blank hdd:

- press shift+f10 when on the partition management screen in setup <-- this opens a command prompt
- diskpart <-- start the windows command line partition management tool
- list disk <--- list the installed hdds in this computer for the next step
- select disk 0 <- might have to replace 0 with the number of the correct disk
- clean <-- this will erase all data on the disk you selected one step up- dont use the wrong disk!
- create partition primary <- creates a primary partition taking up all space on the drive, adjust the command if necessary
- exit, exit to exit diskpart and the command prompt
- click refresh in partition manager and select your newly created partition and install to that

 

Uninstall problem


Open the Admin Command Prompt:

1. diskpart
2. List disk
3. select disk # where # is the disk that contains hidden partitions
4. list par
5. select partition #
6. delete partition OVERRIDE
7. repeat steps 5 & 6 for the additional hidden partitions.
8. exit

OR:
if you want to clean the whole disk, after step 3 above
Type: clean
Type: exit

 

Windows 10 1709 System Restore problems...

That seems to be an attempt at Option 2 in the tutorial, which requires you to
a. Boot to a command prompt (Did you?)
b. You then seem to be mixing steps 3,4 and 5, thus your command is incorrect.

I suggest Option 1 is easier.

If you still have problems, please repost listing each specific step and saying which option from the tutorial you are using. Thanks.