Windows 10: Pc automatic repairs and crashing

Hello i bought a nzxt computer and everything has been fine till the other day my pc randomly went into automatic repairs i left it there for a bit and didnt do nothing so i turned it off and tried again same thing turned it off again and this time it said press any key to skip disk cheking i did and i got in ive been searching online and some people said reset the pc and im fine with that since i have nothing important on my pc and ive been trying and trying and it will not reset on the blue screen where u can trouble shoot i even have an nzxt built in reset and even then i wont reset to fact

:)

 

Windows10 Automatic Repair

Hi,

This issue might have occurred due to corrupted system files that are not letting the operating system to perform repair and boot to the desktop.

We would like to know some information:

• Have you tried booting in
  Safe Mode? If not, we suggest that you try it. Check this article for information.
• What troubleshooting steps have you done so far? We need to know it for us to know what other troubleshooting steps to give.

You can check the troubleshooting steps provided by Deepika Gowda on this

link.

We will wait for your response.

 

HELP! Windows 10 automatic repair couldn't repair PC. Details below

Hi Matthew,

As you are facing issue withAutomatic Repair, we would assist you for sure.

In order to understand the issue in a better manner, please share the following details

• 
  I tried system restore” What is the error exact error message you received?
  

If automatic repair fails, you may try to repair them using these commands through Command Prompt under Advanced Options. Follow the steps:

Since you have done most of the troubleshooting steps, I would suggest you to try repairing the Boot Configuration Data through the command prompt by following the steps below and check if it helps.

I suggest you re-built the boot record by following the below commands and check if it helps.

You will have to use Windows 10 installation media to follow the steps to boot into Recovery Environment and try to rebuild BCD.

Step 1: I suggest you to create an installation media for
Windows 10 using the media creation tool:

Installing Windows 10 using the media creation tool

Step 2: After preparing the installation media, insert it hard reboot the device and follow the below:

• Boot into Windows Recovery Environment using the Windows 10 installation media.
• Click on Repair your computer.
  
• Click on Troubleshoot and in the advanced options.
• Select Command Prompt. Type the following commands into the prompt and press Enter key after each command.

• 
  bootrec /fixmbr
  
• 
  bootrec /fixboot
  
• 
  bootrec /scanos
  
• 
  bootrec /rebuildbcd
  

5. Restart the computer.

NOTE: Modifying BIOS/ complementary metal oxide semiconductor (CMOS) settings incorrectly can cause serious problems that may prevent your computer from booting properly. Microsoft cannot guarantee that any problems resulting
from the configuring of BIOS/CMOS settings can be solved. Modifications of the settings are at your own risk.

Hope it helps. Reply to the post with an updated status of this issue for further assistance.

Thank you.

 

Automatic Repair Loop

Hi Charlene,

Your concern regarding the device going into an Automatic Repair Loop can be caused by change on its settings/configuration or broken system files. To effectively assist you with your concern, can confirm if you've made any changes on your device prior to
your concern?

As an initial step to get back into the normal Windows screen, we suggest that you perform a
Startup repair. The repair will attempt to fix any broken components/files which may prevent your device from booting properly. To do this, follow the steps below:

• On theAutomatic Repair screen, select Advanced options.
• Select Troubleshoot.
• Select Advanced options.
• Select Startup Repair.

We'll appreciate if you can send us an update.