Windows 10: PC Blue Screening and Boot Device Stops Being Recognised Afterwards

Hi All,Since I rebuilt my PC in January, I’ve been occasionally blue-screening ranging from multiple times a day to once in two weeks. I don’t remember all of the error codes but they include Memory Management Error, Winload.efi, critical process has stopped working, etc. Every time this happens, when the PC restarts, my boot drive Samsung 990 Pro stops being recognised by my PC. It’s worth noting that my old boot drive Samsung 980 Pro is still in my PC. When I installed Windows to my new drive, the old drive was still plugged in. Since then I have complete wiped and formatted the old boot

:)

 

Startup Blue Screen

Hi Jon,

Startup blue screen error(s) can occur if a problem causes your PC to shut down or restart unexpectedly. It could be due to the following:

• Outdated device software drivers
• Corrupted Windows update system files
• Software/Security conflicts

We would like to know some information:

• Did you get any blue screen stop error codes?
• Have you tried booting in Safe mode?

We suggest that you check this
article about troubleshooting blue screen errors and follow the troubleshooting steps provided there.

We will wait for your response

 

Blue screen and stop code

Hi
Jeferis,

There are a lot of factors for this matter to occur. To isolate the issue, we have some questions for you:

• 
  What activity have you done to
  trigger the NTFS and FAT FILE SYS loop?
  
• 
  were there any error messages?
  
• 
  What troubleshooting steps have you done so far?
  

It is possible that the
Boot
Sequence were corrupted by the previous activity which
triggered the Blue Screen Error and the loop. We recommend that you perform these
suggested troubleshooting
and see if there are any changes:

Startup Repair.


To access the
Startup Repair Screen, turn off the
PC 3-4 times(force shutdown),
while on the Blue screen Error. This will route you to the
Startup repair screen:

Advanced Boot Options > click Troubleshoot > Advanced options > Command Prompt

and run the following command:

Run SFC Scan:  

SFC
will
scan
and
run
an
automatic repair
to any
corrupted system files
that it will detect. We suggest that you perform it twice. To run an
SFC scan, follow these steps:  

• 
  Run
  Command Prompt as Administrator.  
  
• 
  Type
  sfc /scannow
  and hit
  Enter.   
  

Boot Record:

This will fix the corruptions on
boot records or boot
sequence. To run this command, follow these steps:

• 
  Run
  Command Prompt as Administrator.
  
• 
  Type the following command:  
  
  • 
    Bootrec /fixMBR  
    
  • 
    Bootrec /fixBoot
    
  • 
    Bootrec /rebuildBCD
    

Update us on how it goes.

Regards.

 

Stop code blue screen sdbus

Hello,

Stop errors (also sometimes called blue screen or black screen errors) can occur if a serious problem causes your device to shut down or restart unexpectedly. These errors
can be caused by both hardware and software issues.

For us to better assist you, we'd like to know the following:

Confirm which build is currently installed on your device. To check, follow the steps below:

• Press Windows key + R, then type in winver.
• Click OK.

• Were there any recent changes made prior to this issue?
• What actions were you performing when normally encounter the said error?

Meanwhile, we recommend performing the suggested steps in this article to
troubleshoot blue screen error on Windows 10.

We'll be waiting for your response.