Windows 10: PC boots to recovery even all windows files is there, MS-OoBe isn't startedreset PC

One day ago, I resetted my PC because I installed a virus and hard shut-down it during it was stopping the services resulting in cannot open .exe files except Ms store apps like Scratch so after few days, I reset no data loss my pc and it worked but when it was installing windows again , it got to 92-97 I don't remember exact and after that it got dragged to 88 and after waiting a couple of hours I force shut it down but the windows was installed, all files were there, no data lost worth like 800GB but it shown Recovery windows to be repaired error code 0xc0000034 I rebuild bcd, tried to r

:)

 

Is MS reconciling with the PC Gaming Community?

What !?? Games For Windows didn't prove to you that MS was serious about PC gaming? /sarc

Actions speak louder than words. So step up to the plate, Microsoft, or STFU.

 

Unable to boot the PC, stuck in recovery mode screen​

Hi Joe,



Thank you for writing to Microsoft Community Forums.



I understand that you are unable to boot the PC normally as it is stuck in recovery mode.

1. Were there any recent updates installed on the PC?
   
2. What is the exact make and model of the PC?
   

I would suggest you to follow the steps mentioned below and check if that helps.



Method 1:



Boot the PC into safe mode with networking and check if you are able to login. Refer the article to

Start your PC in safe mode in Windows 10, refer the section
From a black or blank screen.



Method 2:



Perform a system restore to revert the PC back to the state when everything was working fine. Refer the article

Recovery options in Windows 10, refer the section
Use installation media to restore or reset your PC.



Note:
Do not reset the PC; resetting the PC will remove all the data and installed programs from the PC.



We await your response.



Regards,

Prakhar Khare

Microsoft Community – Moderator

 

Printer isn´t working after latest update.

After the latest update from Windows, my Canon Pixma ip6600 printer isnt working. In Device Manager it shows up as working properly but when I go to print it isn´t listed as an option in any programs. Troubleshoot suggests it´s a USB 2 printer on a USB
3 port and that that´s the problem but that cant be since it worked fine before the update. I´ve tried to uninstall and plug it back in but that doesn´t work either.