Windows 10: PC crashing after installing new m.2 and network card

I recently installed a new m.2 SSD and network card into my pc as my mobo antenna were not working. During the install one of my ram slots has stopped working and my pc starts crashing every now and again. I made sure the SSD was I'm the correct slot Gen 4 and have ran a windows memory diagnostic and it has found an issue. Any help would be greatly appreciated

:)

 

Installing Windows 11 on a new M.2 device.

Hi everyone, I hope yall are well.

I recently ordered a new M.2 drive for my PC as the current one is becoming dysfunctional and causes a lot of system crashes.

My question is how do you install Windows 11 on the new M.2 device that has no files on it after installing it into my PC?

I'm simply going to replace the M.2 with the old one in my computer.

I also have a valid Windows 11 key!

Any help would be gratefully appreciated!

Thank you!

Steven

 

Replacing a M.2 SSD boot drive card

Running Win 10 version 21H1

My rig has a 500 Mb M.2 SSD card as boot (C:\). Troubling Chkdsk runs have caused me to distrust the current card. A replacement M.2 card should arrive in a couple of days and my confidence in myself to successfully swap the cards is limited as I am older now than I was when I started this thread. I AM getting slower.

My MSI B360m Mortar MoBo has provision for two M.2 cards. I am proposing to install the second M.2 card in the empty slot and use Macrium to copy the contents. I'm not sure how to proceed from here. I think I need to re-letter the new card to C:\ and the old card to something else but I'm not sure how to do this.

Suggestions would be appreciated. With any kind of luck, you too will get old.

 

Hyper M.2 X16 expansion card

Intel I7 9700k
Msi Z390 A motherboard
32GB Ram
RTX 2080 GPU

Friend of mines is trying to find out how to enable the Hyper M.2 X16 expansion card through the BIOS to recognize all four NvMe ssd's installed within the expansion card.

I know it's somewhere in the Bios advanced settings but I'm not very familiar with MSI Bios platform I don't know how to guide him through it if anyone here can help us that would be so greatly appreciated.

The Expansion card is placed on the second PCIe Express port furthest from the CPU

If anyone can provide us with easy to follow step by step instructions on where to enable the card and properly configure it within the MSI Bios we would greatly appreciated.