Windows 10: Pc fails to boot.

Hello, so last night i was playing on my pc when the power went out. This morning when i turned on my pc but it just wouldn't boot. It took about 20-30 attempts of unplugging and holding the power button to finally make it boot. The cd rom always blinks 3 times and makes a weird noise that it always made, now it does it twice. When that doesn't occur i can see the hdd activity light blinking and the noises the hdd makes when it usually boots up but no display. There is absolutely no problem with the monitor. I have absolutely no money to spend on any new pc so if this one will just not boot anymore im screwed.

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

HD 5870 Bios flash failed

mp3 player is in FAT / FAT32 format ?

Set Boot up first to the drive with hiren bootcd 10.4
Done...

the options will pop out after loading the disc choose

boot cd

then the list (step by step)

Next...
Dos....
USB Drivers....
Load USB Drivers with no386.....

Ask you load cd drivers. NO
Ask you load SCSI drivers. NO
Ask you anything NO.
USB driver list comes out. 8 Don't choose anything else.

type
C:\ (that should be your mp3 player if you did it right)

atiflash -i
to list the adapters

atiflash -p -f 0 ???.bin

done.........

 

Windows 10 "Reset this PC" failed upon final boot.

Hi Cathy,

Failing to reset the PC may happen due to several reasons. To isolate your issue, kindly answer the following questions:

• Were you able to boot using the ISO file that you downloaded?
• What troubleshooting steps have you done so far?

When booting the PC using USB recovery tool, please make sure that the first boot source in your PC's BIOS is the USB drive and not the hard drive. It is best to re-download the ISO file to make sure that you have the latest version.

Keep us updated with the status of this concern and we'll be glad to assist you further.