Windows 10: PC freezes and I have to do a hard reset, not sure where the issue can be

Hello I have this systemrocessor 12th Gen IntelR CoreTM i7-12700KF 3.61 GHz Installed RAM 16.0 GB 15.8 GB usable System type 64-bit operating system, x64-based processor Windows 11 ProAsus Prime Z690-ASapphire Radeon RX6600What I am experiencing is whilst playing Age of Empires 4, suddenly my computer freezes and does nothing I cannot control +alt+ del, cannot minimize nor do anything it does not respond unless I do a hard button power off. I have done everything I have read online such as:-Drivers-SFC Scan Now-Clean Windows 11 install-Check Memory Ram with memdiagnostics no errors

:)

 

GPU-Z 0.7.8 / 0.7.9 / 0.8.0 Bios reading not possible GTX670-solved with gpu-z 0.8.1

@Maban - does GPU-Z fail the same way for you the way it does for me? I.e. total system freeze/lockup, requiring a hard reset?

@W1zzard - I will try the suggested steps later today, as I am not near that PC at the moment.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Windows 10 hangs/freezes on Restart

If this happens even during installation, that means that it is probably a hardware issue. To troubleshoot the problem, I suggest doing the following steps:

1. Install Hard Disk Sentinel and use it to check your HDD/SSD for problems.
   
2. Use MemTest to make sure that your RAM is ok. Here is a how to - guide.
   

After You done these two steps, give a feedback of the results.