Windows 10: Pc freezing after a windows update at the bios launch screen

While I was doing an update to windows recently, when it restarted it froze on the spinning wheel start up. I've looked up everything I can to figure out what is causing it but to no straight answer yet. https://imgur.com/a/VIcJTx2Here's a video of me trying to do a clean install to a new hard drive. It's essentially the same end result to everything I try.

:)

 

Windows Vista Wont Install Freezes?

had the same problem, freezes and long installation including each step loading, in my case a bios update helped.

 

Friends computer freezing at windows loading screen

Ok my friend is having problems with his computer right now. Basically it crashed on the windows loading screen. This is what he told me on MSN.

Now i'm not too sure what the problem is. I suggested doing a repair install with the xp disk (i'll be giving him that tomorrow) but in the mean time do any of you have any ideas?

 

Desktop PC boots to black screen after ASUS BIOS update

After searching around Google, I came upon a post where somebody experienced a similar issue and managed to fix it by simply doing the following:

1. Force the PC to shut down
   
2. Unplug the power cord from the PSU for 20-30 seconds; enough so that there's no dormant power left over
   
3. For good measure, if your motherboard/CPU has embedded graphics, temporarily connect your monitor to that instead of your GPU
   
4. Plug the power cord back in and then boot the system
   

Some notes:

• This is strictly for desktop PCs (not laptops). If you're on a laptop,
  you might need to disconnect both the power adapter and the battery
  to completely shut it down
  
• If your system was not bricked because of the BIOS update, you should see a
  message on the screen stating that the BIOS update is resuming, and
  that you should not cut the power to the PC
  
• If the BIOS update was successful, your PC will restart again to a
  vanilla POST screen (not the splash screen) and you will need to
  press F1 here and to set everything in the BIOS back to your own
  
  preferences again
  
• From what I can tell, the BIOS update did succeed after the
  
  flash in the BIOS, but the installation simply glitched out and
  failed to complete the remaining steps after restarting
  

Some things I should've done before I updated my BIOS:

• Saved a copy of my BIOS configurations to a .CMO file in a USB drive
  
• Reset my BIOS settings to default before the update