Windows 10: Pc reset gone wrong

I attempted to reset my computer, and while it was in process i came back not too long later. When i came back, it was on a screen that says to select my account to continue. I am able to select it, but every passcode I enter comes up as incorrect, and I am positive I didn’t forget it. Is there anything I can do to somehow get out of this stage? Note: i currently don’t have access to windows installation media

:)

 

Why did the startup window get cleared?

I didn't missed any step, the list was gone and gone , even after using lot of programs the programs were not listed in that list.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

wrong bios programmed on my card what now?

are you kidding? or is this being lost in language barriers?(if so, then id suggest trying google translateon the list above, or reading it several times, im sorry that i cant help with that part) the PCIe slot is what you need, thats where you plug the GPU into. follow the step by step guide, that is your solution. VGA= Video Graphics array, or adapter in this case, AKA GPU, Aka, Video Card.

The 2nd gpu acts as a way to boot into OS since you're not able to do so with the damaged GPU. I don't know what your system specs are but if you have onboard graphics enable them in your bios and then reset your PC or do it after a reset depending on what your motherboard requires that will allow you to boot into your operating system then follow the steps after number three in the list above.( note that if you do not have built-in graphics on your CPU this is where you will use a second GPU )

i hope this helps......Best of luck, i have 35minutes to get dressed, and be on a transport to Kessel.......another day covered in Spice, *Frown (atleast im working in the Refinery *Wink )