Windows 10: Pc restart loop after factory reset

I recently did a factory reset on my dell laptop and after the reset was done and it was time for the setup i put in my country, app language, keyboard layout, and timezone then i got an error message basicaly saying it needs an update and to plug it in and connect it to wifi so i did so and it is in a loop where the same thing happens but it doesnt let me connect to wifi

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Dell Inspiron 15 stuck in factory reset loop


I have a Dell Inspiration 15 with win 10. it was bogged and slow as syrup on 125 degree day. I did a factory reset. I followed the instructions went to settings, and just followed the steps. At some point during the reset it asked me about tpm2 settings...I had never seen that before so I followed the recommended choice and went to bed. When I got up it asked me for the usual stuff, location, language, time zone. Then it wanted the name of my WIFI and my password, which I gave. It restarted, then just kept on restarting asking me the first set of questions, language, time zone...over and over, it never asked for internet name or password again, . I can get in to the bios settings by using the f8 key.
Any suggestions? Hopefully...
OH I almost forgot, when you do a hard restart, it flashes a tpm2 settings error right before it starts with the dell screen and spinning dots

 

Looping after factory reset


There is not much to do than again factory reset your computer.

Dell SupportAssist OS Recovery starts automatically if Windows will not startup. The recovery environment allows you to diagnose hardware issues, repair issues, back up files, and restore factory settings. You can start the recovery environment at any time.
Verify the list of systems on which Dell SupportAssist OS Recovery is supported.

You should able to factory reset with Windows 10 Installation DVD. You can create Windows 10 installation DVD/USB with Windows 10 Media Creation Tool.