Windows 10: Pc running, but no signal on screen.

So yesterday I decided to factory rest my comouter installing windows from the same device and deleting every file from every disk and because when it started the factory reste my screen went black I dexided to tuen off my comouter because I wanted to see what % it was. So I turned my computer back and it said something like "there was a peoblem resetting your computer" so I just decided to re factory reset and same thing, a black screen. So I do the same thing close and reopen the computer but this time no signal on my screen, but the computer still run without a problem. I try to unplug my

:)

 

PC Build Steps

Ok just because I like steps i am going to create some steps. Please give me the stamp of approval/disapproval

• Install system in case
  • Remember to connect SSD and optical to same SATA ports on motherboard
• Turn on PC
• setup HDD
• run blend test in prime95 for 30-60 min
  • run realtemp at the same time

• While in Prime95 test
  • if CPU goes above 70c in RealTemp, I have a leaky CPU
  • if my system locks up or blue screens, there is an instability in the system somewhere
  • if my system does not lock up or blue screen, my CPU is not damaged and I am in the clear!

What do you guys think??

 

PC Build Steps

1.1 - Ideally put optical in SATA 0, and SSD in SATA 1, this will cause the optical drive to be the default 1st boot option. You can change it manually if not, but I like it this way
2.infinity - yes, that's fine. if it's above 70 +/- 5 degrees, then it may just need a repaste/remount

 

PC goes into black screen and froze

Yeah I'm pretty sure that's not a software related issue which is why I was suggesting that you remove the video card to start with since it's such an easy process of elimination step.

I'm not familiar with AMD CPUs, I did see that you had listed in your system specs but I had no idea whether or not it has an iGPU

Is there any possibility of you being able to get your hands on any compatible video card at all?it would be the easiest step to try to troubleshoot or at least one of the easier ones. You should be able to get into the bios without anything but A display cable hooked up to the motherboard