Windows 10: PC Shutting down due to hardware

my desktop has been restarting on its own recently. i analyse the dump files using BlueScreenView, which identifies errors related to the driver ndiscap.sys, pci and UsbHub3 . I updated the Intel Ethernet Connection 17 i219-LM driver to address the ndiscap.sys issue, but it did not resolve the problem. I'm unsure if this is a hardware or driver conflict. Could anyone advise? Thanks.

:)

 

Laptop won't shut down

Hi Muhammad,

Most of the time, the issue regarding a device that won't shut down properly may be caused by a system conflict after an update or that there are some incompatibility issues. To assist you with this concern, we recommend that you run the troubleshooter.
To do this, kindly follow the steps listed below:

• Type troubleshooting in the Search bar and press
  Enter.
  
• Click on View all on the left-side of the page.
  
• Click on each category below then follow the on-screen prompt to run the troubleshooter:
  

• Background Intelligent Transfer Service
  
• Hardware and Devices
  
• Power
  
• Windows Update

Note: Make sure that you restart your PC after running the troubleshooter for each category.

Let us know how it goes after performing the suggested steps.

 

Received a SYSTEM_THREAD_EXCEPTION_NOT_HANDLED BSOD due to CMUSBDAC.sys

Hello,

A stop error (also called a "blue screen" error) can occur if a problem causes your PC to shut down or restart unexpectedly. These errors can be caused by both hardware and software issues.

For us to better assist you, we'd like to know the following:

• Confirm which build is currently installed on your device. To check, follow the steps below:

• Press Windows key + R, then type in winver.
• Click OK.

• Were there any recent changes made prior to this issue?
• What is the make and model of your device?

Meanwhile, we suggest performing the steps on this article
on how to troubleshoot blue screen errors on Windows 10.

We look forward to your response.

Regards.

 

Cheap Photo box that will get the job done

WEll i took on this project for PP hes a hardware reviewer and wants to get the professional looking pics for the Pc parts

Materials:

• Big cardboard box

• a razor

• white material 3 yards

• cone lights

• stapler

• medical tape

• pvc pipe about 6 inches longer than your box

• white paint any cheap finger paint would work

the project I'm guessing will cost me $30 if it works out properly
I will post pictures and step by step as i do it