Windows 10: Pc so laggy after Reset.

Yesterday,I had reseted my pc including all drives.After reset i had installed all necessary apps,software,etc and i shut downed my pc.And after sometime i open my pc it seems very laggy.After so laggy for about more thn 10 min it crashes and bsod driver power state failure occured. So i understood prob is with driver ..so after crash pc reopened and no problem..but after i shut down and reopened it again occured{not bsod but laggness}very laggy...so now im doing tht i will force shut down and reopen pc to fix the prob..thts only solution if it occur{it always occcur when i open pc}.


And tht laggness occur when we install any drivers or restart any drivers too..so i need to force shutdown it and reopen again..

i had updated all drivers even installed all from its own website..but still problem presist.


before resetting there is no problem..i had tried most videos in youtube but no fix..i had changed power plan to high,ultimate but no use


pc specs ryzen 5 3600,ddr4 8gb @2400,gtx1650


so i need to know how i fix this issue...

:)

 

Laggy

Hi Wilson,

Thank you for writing to Microsoft Community forum.

• What is the make and model of the computer?
  

I suggest you to try the troubleshooting steps listed in Troubleshoot
lags or freezes in Windows and check if it works.

Note: The article holds good for Windows 10.

You may also go through the suggestions given in Tips to improve PC performance in Windows
10 to help make your PC run better.

Note:

Reset will result in the loss of data and the applications installed. You may take a backup of the data before reset.

Regards,

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Unable to reset the pc

Hello,

If you are having that message while trying to reset your computer, We suggest you to create an installation media for Windows 10 using Media
Creation Tool and perform a Reset.

Once the installation media is created, follow the steps below:

• Insert the installation media you created, and then restart your PC.
• On the Install Windows screen, select Repair your computer.
• On the Choose an option screen, select Troubleshoot. From there, you can use Safe Mode. Select
  Advanced Options >Reset This PC>Remove everything.
• After the reset is complete, check for status.

Give us an update on what happens.