Windows 10: Pc stuck in boot loop after bios

Hello, i recently got new ram for christmas and installed it, everything was fine, untill i enabled xmp, then windows would boot and i always got into the advanced settings tab, after then resetting my windows, everything was fine again, installed the latest drivers, all my inportant apps and so on.After i was finished updating and installing i thought to again enable xmp, which then led to the same problem, but now everytime i turn my pc on, i get to the bios, i can enter the bios and use it, but after the bios the pc just keeps restarting and is in a constant Boot Loop, i’ve swapped the ram

:)

 

BIOS stuck in a loop.

Hello,

We would like to ask some additional information to better isolate the issue:

• Did you get any error messages?
• Have you tried to boot in Safe mode?

We suggest that you check the solutions provided on the links below:

BIOS-loop

Stuck-in-BIOS-loop

We will wait for your response.

 

Computer Stuck in Boot Loop

Hi,

We are glad that you tried some troubleshooting steps to fix the issue, but usually the issue occurs due to corrupted system file. In order for us to assist you, we suggest to check this thread and look for Deepika Gowda answer. It contains troubleshooting
steps pertaining to the issue:
Computer stuck with a reboot loop on Windows 10.

We look forward to your response.

 

Stuck in Windows 10 Upgrade

My computer seems to be stuck in a Windows 10 failed upgrade loop. I was running fine on a beta version of Windows 10, and then I came downstairs one morning to see it repeatedly booting, attempting to repair, then rebooting. The steps I've taken to diagnose are:

• Attempting to boot off a USB drive (with all drives disabled in BIOS) - this fails at the point of the blue windows screen
  
• Attempting to boot the machine itself and getting into "repair/safe mode" using F7
  
• Looking at the BIOS for obvious failures (e.g. RAM that should be there is missing) - nothing obvious is wrong.
  

I am fairly certain the build version was 9926. For many months, the system would attempt to upgrade, and then say "it failed" for some reason and roll back.

Suggestions for next steps?