Windows 10: PC will install windows but crashes during setup and wont boot up

I just built my own pc with a AMD 5600x cpu, AMD 6700xt gpu, 970 Evo plus m.2 ssd, 16x2 ram, and a TUF B550-PLUS wifi II motherboard. The first time I booted up my pc, I installed Windows 11 with a USB thumb drive and managed to finish setting it up. However, while I was playing around with settings, my PC suddenly crashed. When I tried to turn it back on, all four POST lights would blink, the monitor would turn on for a few seconds, then would receive no signal. Power continued to go through the board because the fans kept spinning, but the boot failed each time I would restart. I tried reins

:)

 

Windows 7 wont install drivers

+1

If you having an issue installing a driver that worked before you formatted or wont install on a fresh build, sometimes this means hardware damage

 

Windows 7 wont install drivers

i dont think anyone here understands what your asking either when its nearly a 90% english dominated Tech forum.
Step 1
reinstall windows from scratch
Step 2
install all drivers from the cd that came with the god damn motherboard *common sense*
Step 3
update windows
Step 4
install misc etc crap like flash java etc etc
Step 5
Install GPU drivers
Step 6
go back to using your pc without issue.

 

PC wont boot up (No POST, No Video)

I recently installed a new Asus M5A99X Evo r2.0. The motherboard green LED lights up and the case and cpu fans spin. But there is no video when its hooked up to my monitor.

Steps that i have tried:
http://www.tomshardware.com/forum/261145-31-perform-steps-posting-post-boot-video-problems

Made sure all connections are properly connected.

Flashing the CMOS

Tested the PSU

Followed all steps in the user manual

If there are any links that you guys can point me to or suggestions that could help it would be highly appreciated. Thank you