Windows 10: Pc will not send signal to monitor

So last night i was playing games om my pc stationary, 5700x, 3070ti, 32gb ram, etc. then i shut it down to get som food and when i got back it would not send signal to the monitor. All the fans and the gpu light turn on. I cannot het in to bios or enything. In have tried new monitor. New cable, new gpu. Other gpu slot. Reseating ram and gpu. What do i do?

:)

 

Monitor not receiving signal from pc after using hdmi passthrough

Hi,

Thank you for writing to Microsoft Community Forums.

HDMI Pass-Through does not work with all devices. Before attempting to set up an HDMI Pass-Through connection, you should make sure the source of the signal such as a Blu-ray player or Set Top Box, supports HDMI Pass-Through.

In order to get clarity on this issue and assist you with appropriate troubleshooting steps, please reply with the answers to the questions below.

1. Did you try a different HDMI cable to connect your PC to the monitor?
2. When you say "my pc will not display to my monitor", are you able to see any error message on it? For example: 'No signal'.

Meanwhile, try the below suggestions and check if this helps.

• If your monitor has an option in the Menu Button to switch the
  Input Source to HDMI Port, I would suggest you to try it.
• Try completely disconnecting your Xbox from the computer and just connect your computer to the monitor and check if you are able to see the display on the monitor.
• Make sure your display is plugged in and turned on.
• Unplug the video cable from both your display and PC, and then reconnect them firmly. After you reconnect the video cable, try moving your mouse on your display.
• Try connecting to different video outputs on your PC. Sometimes a change in driver can cause the video to be sent to a different display adapter or output.
• If you have your own display adapter installed and connected to your display,
  try connecting your display to the built-in video on the motherboard.
• Check for damaged HDMI cable, loose connections, or faulty adapters.

Hope it helps.

We're looking forward to your response.

 

PC boots up but monitor shows 'no signal' and keyboard not working.

'No signal' means that your monitor is not receiving a video signal that it can display. This is usually due to one of the following causes:

1- The cable going from your computer to your monitor is loose. Power off the monitor, re-attach the cable at both end, power on your monitor. (This step is N/A if you have a laptop or an AIO.)

2- The signal your graphics card is sending to your monitor can't be displayed by your monitor. Boot the computer to Safe Mode, choose a low resolution signal, restart your computer normally, switch to the 'Recommended' resolution for your monitor.

To change the signal resolution: Start > Settings > System > Display > Display resolution.

Your problem is not related to your BIOS, unless you made changes to the BIOS yourself.

 

no signal on monitor

Hello Justin, It sounds like your PC might be encountering a hardware issue.

Here are a few steps you can try to troubleshoot:

1. Power Supply: Make sure the power outlet is working by testing it with another device. Also, check the power supply unit (PSU) of your PC to see if it's functioning properly.
   
2. Hardware Reset: Turn off your PC, unplug it from the power source, and hold down the power button for about 30 seconds. Then plug it back in and try turning it on again.
   
3. RAM Check: Reseat the RAM sticks (if accessible). Sometimes reseating them can resolve issues related to no display.
   
4. Graphics Card: If you have a dedicated graphics card, ensure it's seated properly in its slot.
   
5. BIOS Reset: Resetting the BIOS settings to default might help. This is usually done by removing the CMOS battery on the motherboard for a few minutes and then putting it back in.
   

If these steps don't resolve the issue, make note of any changes, so we can better pinpoint the issue and we can further troubleshoot.

-RD_LaBs